Installation Guide

10 FR-W1815

6. Hanging the Fan (cont.)

1. Carefully remove and discard the blue shipping cap from

the top of the motor housing, ensuring that the lead wires

and safety cable do not become twisted.

2. Remove the 3 screws from the blue shipping cap on the

bottom of the motor housing and keep them for use with

the light kit adapter plate. Discard the blue shipping cap.

3. Take out the set screw located in the hanger ball, lower the

hanger ball and remove the cross pin. Remove the hanger

ball from the hanger ball/downrod assembly (Fig. 8).

4. Remove the clevis pin and cotter pin, and loosen the two

collar screws from the motor collar (Fig. 9).

5. Carefully feed the motor wires and safety cable up through

the downrod. Thread the downrod into the collar.

6. Align the holes of downrod and collar and insert the cotter

pin and clevis pin. Tighten the two collar screws (Fig. 9).

WARNING: Failure to properly install the cotter pin and/or tighten the

screws could result in the fan loosening and possibly falling.

FIGURE 8

Cross Pin

Hanger

Ball

Downrod

Clevis Pin

Cotter Pin

Screws (2)

Collar

Safety Cable

Motor Wires

Set Screw

FIGURE 9