Installation Guide

10FR-W1816
7. ATTACHING THE FAN BLADES
8. INSTALLING THE LOWER HOUSING
Screws with
rubber washers
Slot
Blade
Mounting ring
Screw
Adapter
plate
1. Locate motor assembly and place it upside-down on a soft
surface.
2. Insert the fan blade through the slot in the housing. Align the
holes in the blade with the fan motor assembly holes and secure
with a blade attachment screw with rubber washers (Fig. 8).
3. Repeat this procedure with the remaining fan blades.
1. Remove one of the three mounting plate screws from the
mounting ring and loosen the other two screws (Do not remove).
2. Place the key holes in the lower housing over the two screws
previously loosened from the mounting ring. Turn the adapter
plate until the mounting plate locks in place at the narrow section
of the key holes (Fig. 9).
3. Securely tighten the two mounting plate screws previously
loosened and the one previously removed.
FIGURE 8
FIGURE 9