Installation Guide

12FR-W1816

10. HANGING THE FAN

1. Remove the clevis pin and cotter pin and loosen the two collar

screws from the motor collar (Fig. 16).

2. Feed motor wires through coupling cover, canopy ring, and

canopy.

3. Feed motor wire through downrod assembly.

4. Thread the downrod assembly onto motor collar. Align the holes

of downrod and collar and insert the cotter pin and clevis pin.

Tighten the two collar screws (Fig. 16).

WARNING: Failure to properly install the cotter pin and/or tighten the

set screws could result in the fan loosening and possibly falling.

FIGURE 16

Downrod Assembly

Canopy Cover

Canopy Ring

Coupling Cover

Clevis Pin