Installation Guide

18FR-W1816
13. FINISHING THE INSTALLATION
1. Secure all wire connections with supplied wire ties to assist in
canopy installation.
2. Tuck connections neatly into ceiling outlet box.
3. Slide the canopy up to the hanger bracket and place the key hole
on the canopy over the screw on the hanger bracket. Turn canopy
until it locks in place at the narrow section of the key holes (Fig. 23).
4. Align the circular hole on canopy with the remaining hole on the
mounting bracket. Secure by tightening the one screw previously
loosened and the one screw previously removed.
5. Adjust the screws as necessary until the canopy and canopy rings
are snug (Fig 23).
FIGURE 23
WARNING: Make sure the tab at the bottom of the hanger bracket is
properly seated in groove of hanger ball before attaching canopy to
bracket. Failure to properly seat tab in groove could cause damage to
electrical wiring.