Installation Guide

9FR-W1816
6. INSTALLING THE MOUNTING BRACKET
REMEMBER to turn off the power. Follow the steps below to hang your fan properly:
1. Disconnect power at the breaker to the fan location. A licensed
electrician must install the fan (Fig. 5).
2. Remove 1 of 2 screws from the bottom of mounting bracket and
save for use in section 13. Loosen the other screw (Fig. 6).
3. Pass the 120-volt supply wires through the center hole in the ceiling
mounting bracket as shown in (Fig. 7).
4. Secure the mounting bracket to the ceiling outlet box with the
screws and washers provided with your outlet box (Fig. 7).
FIGURE 5
FIGURE 6
FIGURE 7
Mounting
bracket
Screw
UL/cUL Listed
electrical box
Mounting
bracket
Mounting screws
120V wire