Installation & Assembly

Modern Forms
www.modernforms.com
Phone [phone] • Fax [phone]
Headquarters/Eastern Distribution Center
44 Harbor Park Drive • Port Washington, NY 11050
Phone [phone] • Fax [phone]
Western Distribution Center
1750 Archibald Ave • Ontario, CA 91761
Phone [phone] • Fax [phone]
Modern Forms retains the right to modify the design of our products at any time as part of the company's continuous improvement program.
2
PREPARATION
1. Shut o the power at the circuit breaker and remove existing xture, including the crossbar.
2. Carefully unpack your new xture and lay out all the parts on a clear area. Be careful not to lose any small parts necessary for installation.
CONNECTING THE WIRES Fig. 2
3. Remove the mounting screw (C1) from the mounting xture.
4. Drill a hole in the wall aligned with the key-hole located in the mounting plate, insert the plastic anchor (D1) to the wall.
5. Connect the driver input/output wires to junction box wires as shown (Fig. 2). Make sure that all wire connectors (A1) are secure. If your out-
let box has a green or bare copper ground wire, connect the xture’s ground wire to it. Otherwise, connect the xture’s ground wire directly
to the back plate using the green screw provided. After wires are connected, tuck them carefully inside the junction box.
NOTE: This xture requires driver to be recessed within the junction box.
MOUNTING THE FIXTURE Fig. 1
6. Secure the mounting plate to the junction box using junction box screws (B1). Fasten the mounting plate to the wall using
the wood screw (E1).
NOTE: The side of the mounting back plate marked “GND” must face out.
7. Place the xture on the mounting plate, and secure it with mounting screw (C1).
Fixture Wires
Black or
Smooth
Fixture Wires
White or
Ribbed
Fixture Wires
Bare wire
(Ground)
House Wires
Black
(Hot)
House Wires
White
(Neutral)
House Wires
Green or Bare
Copper
(Ground)
Fig.2 Wiring
Back Plate Dimensions
FIG.1
E1
D1
A1
B1
C1
Wood Screw
Plastic Anchor
Wire Connector
Junction Box Screw
Mounting Screw
Mounting Plate
13 1/4”
1 3/4”
9 1/2”
1 3/8”
4 1/8”
Fixture
Driver
Junction Box
INSTALLATION INSTRUCTIONS
I Beam - Wall Sconce
WS-94614 / WS-94620