Installation & Assembly

2Modern Forms retains the right to modify the design of our products at any time as part of the company's continuous improvement program.
modernforms.com
Phone [phone]
Fax [phone]
Headquarters/Eastern Distribution Center
44 Harbor Park Drive
Port Washington, NY 11050
Central Distribution Center
1600 Distribution Ct
Lithia Springs, GA 30122
Western Distribution Center
1750 Archibald Avenue
Ontario, CA 91760
INSTALLATION INSTRUCTION
257 - LED Pendant
PD-25708, PD-25728, PD-25740
PREPARATION
1. Shut o the power at the circuit breaker and remove existing xture, including the crossbar.
2. Carefully unpack your new xture and lay out all the parts on a clear area. Be careful not to lose any small parts necessary for installation.
CONNECTING THE WIRES (Fig. 2)
3. Remove the mounting screws (C1) from the xture.
4. Secure mounting plate to the junction box using junction box screws (B1). The side of the mounting plate marked “GND” must face out.
5. Connect the xture wires with supply wires as shown in Fig. 2, making sure that all wire connectors (A1) are secured. If your outlet box has
a green or bare copper ground wire, connect the xture’s ground wire to it. Otherwise, connect the xture’s ground wire directly to the
mounting plate using the green screw provided. After wires are connected, tuck them carefully inside the junction box
MOUNTING THE FIXTURES (Fig. 1)
6. Choose the number of down rods suitable of your application.
7. Thread the xture wire through the aluminum bar, rods and canopy.
Connect the canopy, down rod aluminum bar and xture body.
Make sure all are tightened.
8. Thread the clear glass on the top of glass holder, thread the etched glass
on the bottom of glass holder. Secure them with Allen screw (D1) using
Allen wrench (E1).
9. Place the xture over the mounting plate and secure it with mounting
screws (C1).
10. For slope ceiling application, rotate wire at the top of the stem to ensure
luminaries is aiming down (Fig. 3).
Wire Connector
Junction Box Screw
3-12" Rods
6" Rods
Fixture
Junction Box
Mounting Plate
Mounting Screw
Allen Wrench
Allen Screw
Clear Glass
(RPL-GLA-25724-01)
Etched Glass
(RPL-GLA-25724-02)
Aluminum
Bar
C1
E1
D1
A1
B1
FIG. 1 PD25728
PD25708 PD25740
Fixture Wires
Black or
Smooth
Fixture Wires
White or
Ribbed
Fixture Wires
Bare wire
(Ground)
House Wires
Black
(Hot)
House Wires
White
(Neutral)
House Wires
Green or Bare Copper
(Ground)
Fig. 2 Wiring
Ø 4 3/4"
1 1/2"
1 3/4"
Back Plate Dimensions