Assembly Instructions
Modern Forms
www.modernforms.com
Phone (800) 526.2588 • Fax (800) 526.2585
Headquarters/Eastern Distribution Center
44 Harbor Park Drive • Port Washington, NY 11050
Phone (516) 515.5000 • Fax (516) 515.5050
Western Distribution Center
1750 Archibald Ave • Ontario, CA 91761
Phone (800) 526.2588 • Fax (800) 526.2585
Modern Forms retains the right to modify the design of our products at any time as part of the company's continuous improvement program. JULY, 2014
INSTALLATION INSTRUCTION
Cloud
WS-3428, WS-3436
PREPARATION
1. Shut o the power at the circuit breaker and remove existing xture, including the crossbar.
2. Carefully unpack your new xture and lay out all the parts on a clear area. Be careful not to lose any small parts necessary
for installation.
CONNECTING THE WIRES (Fig. 2)
3. Remove screws (O1) and xture backplate (R1) from the mounting backplate (Q1). Remove wire connectors (L1).
4. Connect the transformer’s input wires to junction box wires as shown in Fig. 2, making sure that all wire connectors (A1) are
secured. If your outlet box has a green or bare copper ground wire (M1), connect the xture’s ground wire to it. Otherwise,
connect the xture’s ground wire directly to the back plate (Q1) using the green screw provided. After wires are connected,
tuck them carefully inside the junction box.
*Requires Transformer to be recessed within the junction box
MOUNTING THE FIXTURE (Fig. 1)
5. Secure the mounting backplate (Q1) to the junction box (N1) using junction box screws (B1).
The side of the mounting backplate marked “GND” must face out.
6. Secure the mounting backplate (Q1) to wall using the screws (E1) and the plastic anchors (F1).
7. Connect the xture’s blue and red wires to the transformer’s red output wires; blue to red; red to the other red.
Use wire connectors (L1).
8. Secure the xture backplate (R1) onto mounting
backplate (Q1) with screws (O1).
9. Place the pc shade (J1) onto the xture to cover the led.
COMPLETING THE INSTALLATION (Fig. 1)
10. Secure the end cap (D1) to the glass (K1) using washer
(GG/HH) and hex ange nut (I1).
11. Place the glass (K1) onto the xture backplate (R1) and
secure with screws (C1).
FIG.2
Fixture Wires
Black or
Smooth
Fixture Wires
White or
Ribbed
Fixture Wires
Bare Copper
(Ground)
House Wires
Black
(Hot)
House Wires
White
(Neutral)
House Wires
Green or Bare Copper
(Ground)
K1
G1
H1
I1
J1
O1
R1
E1
Q1
F1
B1
A1
N1
M1
P1
L1
D1
C1
FIG.1