Installation & Assembly

Modern Forms
www.modernforms.com
Phone [phone] • Fax [phone]
Headquarters/Eastern Distribution Center
44 Harbor Park Drive • Port Washington, NY 11050
Phone [phone] • Fax [phone]
Western Distribution Center
1750 Archibald Ave • Ontario, CA 91761
Phone [phone] • Fax [phone]
Modern Forms retains the right to modify the design of our products at any time as part of the company's continuous improvement program. DECEMBER, 2014 2
INSTALLATION INSTRUCTION
Seismic - Vanity
WS-46527, WS-46537
PREPARATION
- Shut o the power at the circuit breaker and remove existing xture, including the mounting hardware.
- Carefully unpack your new xture and lay out all the parts on a clear area. Be careful not to lose any small parts necessary for installation.
MOUNTING THE FIXTURE (FIG. 1)
1. Mark the mounting plate key hole location on the wall. Drill the holes and insert the plastic anchors (G1).
2. Secure the mounting plate (E1) to the junction box using the junction box screws (I1).
3. The side of the mounting plate marked “GND” must face out. Fasten the wood screw (P1) into the plastic anchors (G1) and tighten the
mounting plate.
4. Slide the glass (M1) into the xture, place the end cap (H1) and secure it using screws (C1) from the xture back inside.
5. Put the washer (W1) and the glass panel (Q1) onto the frame (X1). Secure it using the washer (O1) and the screw (N1).
6. Put the frame (X1) onto the xture, fasten using the screw (A1) from xture back inside.
7. Hang the safety cable (J1) onto the slots of mounting plate (E1). This will allow xture to be supported while wire connection are made.
CONNECTING THE WIRES (FIG. 2)
8. Connect the xture wires to supply wires as shown in Fig.2,
making sure that all wire connectors (B1) are secured.
If your outlet box has a green or bare copper ground wire, connect the
xture’s ground wire to it. Otherwise, connect the xture’s ground
wire directly to the mounting plate (E1) using the green screw provided.
After wires are connected, tuck them carefully inside the junction box.
9. Place the xture onto the mounting plate (E1).
Secure them using the mounting screws (A1).
Fixture Wires
Black or
Smooth
Fixture Wires
White or
Ribbed
Fixture Wires
Bare wire
(Ground)
House Wires
Black
(Hot)
House Wires
White
(Neutral)
House Wires
Green or Bare Copper
(Ground)
Fig. 2
Technology Upgraded
No Driver Required
Driver
(Please direct wire with 120V AC)
I1
B1
J1
G1
E1
P1
A1
C1
H1
M1
N1
O1
Q1
W1
X1
Anchor
Mounting Plate
Wood Screw
Set Screw
Fixture Screw
End Cap
Glass
Screw
Washer
Glass Panel
Washer
Fixture Frame
Junction Box Screw
Safety Cable
Junction Box
Wire Connector