Installation & Assembly

Modern Forms
www.modernforms.com
Phone [phone] • Fax [phone]
Headquarters/Eastern Distribution Center
44 Harbor Park Drive • Port Washington, NY 11050
Phone [phone] • Fax [phone]
Western Distribution Center
1750 Archibald Ave • Ontario, CA 91761
Phone [phone] • Fax [phone]
Modern Forms retains the right to modify the design of our products at any time as part of the company's continuous improvement program. SEPTEMBER, 2014
PREPARATION
1. Shut o the power at the circuit breaker and remove
existing xture, including the mounting hardware.
2. Carefully unpack your new xture and lay out
all the parts on a clear area. Be careful not to lose
any small parts necessary for installation.
MOUNTING THE FIXTURE (FIG.1)
3. Insert glass (L1) inside the shade (M1). Secure glass with clips.
4. Fasten the stem (I1) to the LED assembly (J1).
5. Insert the LED assembly (J1) inside the shade (M1) and fasten
arm brackets using screws (K1).
6. Push the cable-grippers on top of shade (M1) and adjust cable
length. Make sure the cables are tight.
7. Choose stem sections needed to hang the pendant at desired
height. Lead the xture wire through the stems and canopy (F1).
Connect the xture and stems to the canopy.
CONNECTING THE WIRES (FIG.2)
8. Connect the transformer input wires with supply wires
as shown in Fig. 2, making sure the wire connectors (C1)
are secured. Tuck wires carefully inside the junction box (A1).
9. Mount the transformer onto the mounting plate (D1)
using the provided double-sided adhesive tape. Fasten the
mounting plate (D1) to the junction box (A1) using junction box
screws (E1). The side of the mounting plate marked “GND” must
face out. *Requires Transformer to be recessed within the
junction box.
10. Trim the xture wires at least 6” from center of canopy (F1).
Carefully strip wires with wire stripper (not provided).
11. Connect the transformer output wires (red) with xture
wires, making sure that all wire connectors are secured.
If your outlet box has a ground wire, connect it to the
xture’s ground wire. Otherwise, connect the xture’s
ground wire directly to the mounting plate (D1) using the
green screw provided. Tuck wires carefully inside the
junction box.
12. Place the canopy (F1) over the mounting plate (D1) and
secure with mounting screws (B1).
INSTALLATION INSTRUCTION
SOLEIL
PD-51418
A1
C1
G1
D1
E1
B1
F1
H1
I1
J1
L1
K1
M1
J1
K1
M1
FIG.1
Supply wire
Transformer
Input
Output
Fixture wire
Fixture Wires
Black or
Smooth
Fixture Wires
White or
Ribbed
Fixture Wires
Bare wire
(Ground)
House Wires
Black
(Hot)
House Wires
White
(Neutral)
House Wires
Green or Bare Copper
(Ground)
Fig.2 Wiring