Installation Guide

3Modern Forms retains the right to modify the design of our products at any time as part of the company's continuous improvement program.
modernforms.com
Phone [phone]
Fax [phone]
Headquarters/Eastern Distribution Center
44 Harbor Park Drive
Port Washington, NY 11050
Central Distribution Center
1600 Distribution Ct
Lithia Springs, GA 30122
Western Distribution Center
1750 Archibald Avenue
Ontario, CA 91760
PREPARATION
1. Shut o the power at the circuit breaker and remove existing xture, including the crossbar.
2. Carefully unpack your new xture and lay out all the parts on a clear area. Be careful not to lose any small parts necessary for installation.
INSTALLATION
MOUNT ON SWITCH BOX (Fig. 1)
3. Remove the mounting screws (B1) from the xture.
4. Connect the driver (G1) input wire to switch box wires as shown in Fig. 3, making sure that all wire connectors (A1) are secured.
If your outlet box has a green or bare copper ground wire, connect the xture's ground wire to it. Otherwise, connect the xture's ground
wire directly to the back plate using the green screw provided. After wires are connected, tuck them carefully inside the switch box.
*Requires Driver to be recessed within the switch box.
5. Secure the mounting plate to the switch box using the junction box screws (C1). The side of the mounting plate marked
"GND" must face out.
6. The back plate location for this xture is adjustable.
First, loosen both adjustable nuts by turning counterclockwise.
Second, adjust the back plate to your desired location.
Third, pull and tighten the electrical wire.
Lastly, secure the back plate by turning both adjustable nuts clockwise.
7. Place the xture over the mounting plate, and secure it with mounting screws (B1).
OR
MOUNT ON JUNCTION BOX (Fig. 2)
3. Remove the mounting screws (B1) from the xture.
4. Connect the driver (G1) input wire to junction box wires as shown in Fig. 3, making sure that all wire connectors (A1) are secured.
If your outlet box has a green or bare copper ground wire, connect the xture's ground wire to it. Otherwise, connect the xture's ground
wire directly to the back plate using the green screw provided. After wires are connected, tuck them carefully inside the junction box.
*Requires Driver to be recessed within the junction box.
5. Secure the mounting ring (D1) to the switch box using the junction box screws (C1). Make sure the two holes (Spacing 2-3/4") are horizontal
as shown in Fig. 2. The side of the mounting plate marked "GND" must face out.
6. Secure the mounting plate and conversion plate (E1) to the mounting ring with assembly screw (F1).
7. The back plate location for this xture is adjustable.
First, loosen both adjustable nuts by turning counterclockwise.
Second, adjust the back plate to your desired location.
Third, pull and tighten the electrical wire.
Lastly, secure the back plate by turning both adjustable nuts clockwise.
8. Place the xture over the mounting plate, and secure it with mounting screws (B1).
Fixture Wires
Black or
Smooth
Fixture Wires
White or
Ribbed
Fixture Wires
Bare wire
(Ground)
House Wires
Black
(Hot)
House Wires
White
(Neutral)
House Wires
Green or Bare Copper
(Ground)
Fig. 4 Wiring
INSTALLATION INSTRUCTION
217 - LED Wall Sconce
WS-21718