Installation Sheet

2Modern Forms retains the right to modify the design of our products at any time as part of the company's continuous improvement program.
modernforms.com
Phone [phone]
Fax [phone]
Headquarters/Eastern Distribution Center
44 Harbor Park Drive
Port Washington, NY 11050
Central Distribution Center
1600 Distribution Ct
Lithia Springs, GA 30122
Western Distribution Center
1750 Archibald Avenue
Ontario, CA 91760
INSTALLATION INSTRUCTION
277 - LED Bath
WS-27728, WS-27737
PREPARATION
1. Shut o the power at the circuit breaker and remove existing xture, including the crossbar.
2. Carefully unpack your new xture and lay out all the parts on a clear area. Be careful not to lose any small parts necessary for installation.
MOUNTING THE FIXTURE (Fig. 1)
3. Remove the dome screws (C1) and mounting screws (F1) from the xture.
4. Drill holes in the wall aligned with the key holes located in the mounting back plate, insert the plastic anchors (D1).
5. Secure the mounting plate to the junction box using junction box screws (B1), fasten it to the wall using wood screws (E1). The side of the
mounting back plate marked “GND” must face out.
6. Insert the glass into the xture, make sure the white screen side faced down,
and secure them with side cover using dome screws (C1)..
CONNECTING THE WIRES (Fig. 2)
7. Connect the xture wires to junction box wires as shown in Fig. 2, making
sure that all wire connectors (A1) are secured. If your outlet box has a
green or bare copper ground wire, connect the xture’s ground wire to it.
Otherwise, connect the xture’s ground wire directly to the back plate
using the green screw provided. After wires are connected, tuck them
carefully inside the junction box.
8. Secure the xture to mounting plate with the mounting screws (F1).
Fixture Wires
Black or
Smooth
Fixture Wires
White or
Ribbed
Fixture Wires
Bare wire
(Ground)
House Wires
Black
(Hot)
House Wires
White
(Neutral)
House Wires
Green or Bare Copper
(Ground)
Fig. 2 Wiring
Glass 2
(RPL-GLA-27728-02)
(RPL-GLA-27737-02)
Glass 1
(RPL-GLA-27728-01)
(RPL-GLA-27737-01)
Wire Connector
Junction Box Screw
Dome Screw
Side Cover
Lamp Body
Back Plate Dimensions
Mounting Plate
Junction Box
Mounting Screw
Wood Screw
Plastic Anchor
A1
B1
C1
F1
E1
D1
FIG. 1
WS-27728: 24 3/4"
WS-27737: 38 3/8"
WS-27728: 17 3/4"
WS-27737: 31 1/2"
1 3/8"
1 3/4"
5 1/4"