Installation Guide

WS-35961/ WS-47919/ WS-47925/ WS-47937/ WS-47949/ WS-47961
Fig.3
3
modernforms.com
Phone [phone]
Fax [phone]
Headquarters/Eastern Distribution Center
44 Harbor Park Drive
Port Washington, NY 11050
Central Distribution Center
1600 Distr
Lithia Springs, GA 30122
Western Distribution Center
1750 Archibald Avenue
Ontario, CA 91760
Modern Forms retains the right to modify the design of our products at any time as part of the company's continuous improvement program. Jan 2019
JANUARY, 2017
modernforms.com
Phone [phone]
Fax [phone]
Headquarters/Eastern Distribution Center
44 Harbor Park Drive
Port Washington, NY 11050
Central Distribution Center
1600 Distribution Ct
Lithia Springs, GA 30122
Western Distribution Center
1750 Archibald Avenue
Ontario, CA 91760
INSTALLATION INSTRUCTIONS
WS-35919 / WS-35925/ WS-35937/ WS-35949
359 / 479 – LED Wall Sconce
Assembly Screw
Silicon Gasket
C
A
Wire Connector
Plastic Anchor
D
Mounting Screw
B
Wood Screw
E
Acrylic Diffuser
PC strip
Decorative
Plate
Junction Box
Ground Wire
End Cap
F
G
PREPARATION
1. Shut off the power at the circuit breaker and remove existing fixture, including the crossbar.
1. Replace or install new slim junction box. Use the two wood screws (E) provided to secure the slim junction box (H) on the wall.
NOTE:
The junction box must be recessed about 1/8" into the surface of the wall.
2. Follow steps 2-6 according to "MOUNT WITHOUT JUNCTION BOX."
NOTE: It is not necessary to drill small access hole in the wall.
2. Carefully unpack your new fixture and lay out all the parts on a clear area. Be careful not to lose any small parts necessary for installation.
INSTALLATION
MOUNT WITHOUT JUNCTION BOX (Fig. 1)
1. Drill a hole according the in
stallation location (Fig. 5), insert plastic anchor (D).
2. Remove the mounting screw (B) and the end cap from the fixture.
3. Drill a small access hole in the wall behind the fixture and pull the house wires through the wall.
4. Connect the fixture's wires to supply wires as shown (Fig. 4). Make sure that all wire connectors (A) are secure. If your outlet box has a green or
bare copper ground wire, connect the fixture’s ground wire to it. Otherwise, tuck the fixture’s ground wire directly to the fixture. After wires are
connected, tuck them carefully inside the wall hole.
5. Slide acrylic diffuser and PC strip slightly out of the way to review the plastic anchor location on the back, then fast en the fixture to the wall
using wood screw (E).
6. Secure the end cap to the fixture using mounting screw (B) to seal the acrylic diffuser.
MOUNT ON SLIM JUNCTION BOX (Fig. 2)