T300A-SI Blue tooth turntable INSTRUCTIONMANUAL
Safety instructions IMPORTANT SAFETY INSTRUCTIONS - READ CAREFULLY BEFORE USE This symbol indicates that there are important operating maintenance instructions in the user manual accompanying this tablet. This symbol indicates that dangerous voltage is present within this tablet, constituting a risk of electric shock or personal injury. Do not use this device near water. Clean only with a slightly damp cloth. Do not cover or block any ventilation opening.
FCC statement in User’s Manual (for class B) Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
IMPORTANT NOTE : (For MobileDevice Configuration) FCCRadiation Exposure Statement: This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator & your body.
Assembly Drive belt: The belt and turntable platter have been installed properly at factory, if the belt is loose during transportation, install it as below: A. Remove the rubber mat from the turntable platter and the E ring from the turntable shaft, then release the turntable platter from the shaft B. Put the drive belt on the inner rim of the turntable platter and pull it through the hole C. Hold the belt with your fingers and place the belt onto the motor pulley as shown in the drawing.
FEATURES 1. 2. 3. 4. 5. 6. 45RPM Adaptor: Use this adaptor when playing 45 RPM records. Switch 33 or 45 rpm for playing a record at a correct speed. Pick-up arm stand Pick-up Arm Lift Stick: To raise up and down the Pick-up Arm and cue at a proper place of a vinyl. Arm rest and lock 33/45 RPM Switch: Blue tooth knob with LED: Press this knob to seraching a speaker Press 1 second, to switch ON or OFF the blue‐tooth function. Press 2 seconds to start or cancel pairing The LED indicating as below.
8. 9. Power LED: It’s light while the unit is turned on. Volume control: To adjust the volume of headpone and Blue tooth output. 10. Reject Press it to force the arm to return directly to the arm rest 11. RCA Line Out Cable Connect the RCA line out to a mixer or an amplifier 12. USB connector: Connecting B-type USB cable to PC for recordingby the music editing program the users have. User also can download the free program from internet as below: www.audacity.com 13.
4. Press the Blue‐Tooth switch for 2 seconds for pairing to speaker, the LED will twinkling fast. 5. Once the bluetooth connect to a speaker, the LED is light. 6. Press the Blue‐Tooth switch for 2 seconds to disconnect the paired connection, and the LED is off 7. While the bluetooth is connected with a speaker, if the speaker is switched off or out of the available area, the blue tooth of turntable will be in standby mode, and the LED is twinkling.
z Switch off the power, if you do not play it.
