Installation and Service Manual

ManualsBrandsModine ManualsHeating30 Degrees - Downward Air Deflector

6-598.4

5H079578A

August, 2009

INSTALLATION INSTRUCTIONS

30°, 60°, and 90° downward deflector hoods

and vertical air deflector blades

models HD/HDB, HDS/HDC, PTC, PTS/BTS

THIS MANUAL IS THE PROPERTY OF THE OWNER.

PLEASE BE SURE TO LEAVE IT WITH THE OWNER WHEN YOU LEAVE THE JOB.

ACCESSORY DOWNWARD DEFLECTOR HOOD VERTICAL AIR DEFLECTOR BLADES

WARNING

Gas supply shall be shut-off and the electrical power

disconnected before proceeding with the conversion.

Failure to do so could result in fire, explosion, electrical

shock, or the unit starting suddenly resulting in injury.

IMPORTANT

1. The use of this manual is specifically intended for a

qualified installation and service agency. All installation

and service of these kits must be performed by a

qualified installation and service agency.

2. These instructions must also be used in conjunction

with the Installation and Service Manual originally

shipped with the appliance, in addition to any other

accompanying component supplier literature.

TABLE OF CONTENTS

Instructions – Downward Deflector Hood...……………….2-3

Instructions – Vertical Air Deflector Blades………….………4

Summary of content (4 pages)

PAGE 1
6-598.4 5H079578A August, 2009 INSTALLATION INSTRUCTIONS 30°, 60°, and 90° downward deflector hoods and vertical air deflector blades models HD/HDB, HDS/HDC, PTC, PTS/BTS ACCESSORY DOWNWARD DEFLECTOR HOOD WARNING Gas supply shall be shut-off and the electrical power disconnected before proceeding with the conversion. Failure to do so could result in fire, explosion, electrical shock, or the unit starting suddenly resulting in injury.
PAGE 2
INSTALLATION – DOWNWARD DEFLECTOR HOOD Deflector Hood Model Application The 30°, 60° and 90°, Downward Deflector Hoods are designed for use installed propeller and blower unit heaters. 3. Assembly/Installation The recommended procedure for assembly and installation is described as follows: 1. Before beginning installation of the accessory hood, remove all of the spring loaded louver blades from the unit heater on which the hood is to be installed.
PAGE 3
INSTALLATION – DOWNWARD DEFLECTOR HOOD 9. If 60° or 90° hoods are being assembled, it is necessary to connect two 30° sections together for a 60° hood, and three 30° sections for a 90° hood. See Figure 2.2. a. For hoods with multiple sections, connect the sections together by attaching the left and right side panels to the front of the previous section using the upper and middle mounting holes on the side plates with #10 x ½” self drilling screws. b.
PAGE 4
INSTALLATION – VERTICAL DEFLECTOR BLADES Vertical Deflector Blade Model Application Figure 4.1 – Vertical Blades Exploded View The Vertical Deflector Blades are designed for use with propeller and blower unit heaters. Installation of the assembly is easiest prior to unit installation. Assembly/Installation The following section contains the recommended procedure for assembly and installation of the vertical louver blade assembly. Note that model sizes 30-155 feature a single bank of louvers.