Install Instructions

ManualsBrandsModine ManualsHCH Series Lodronic Low-Temperature Heaters22,000 BTU HCH Lodronic Low-Temperature Hydronic Heater

1-660.0

5H0827900000

August, 2019

INSTALLATION INSTRUCTIONS

30°, 60°, and 90° downward deflector hoods

Lodronic

Models HCH

THIS MANUAL IS THE PROPERTY OF THE OWNER.

PLEASE BE SURE TO LEAVE IT WITH THE OWNER WHEN YOU LEAVE THE JOB.

– ACCESSORY DOWNWARD DEFLECTOR HOOD

IMPORTANT

1. The use of this manual is specifically intended for a

qualified installation and service agency. All installation

and service of these kits must be performed by a

qualified installation and service agency.

2. These instructions must also be used in conjunction

with the Installation and Service Manual originally

shipped with the appliance, in addition to any other

accompanying component supplier literature.

Deflector Hood Model Application

The 30°, 60° and 90°, Downward Deflector Hoods are

designed for use on Lodronic

hydronic unit heaters.

Assembly/Installation

The recommended procedure for assembly and installation

is described as follows:

Before beginning installation of the accessory hood,

remove all of the spring loaded louver blades from the

unit heater on which the hood is to be installed. These

blades will be relocated in the face of the hood

assembly after the hood assembly is complete (except

90° hoods). Not all blades from the unit heater will be

used on the hood, but all should be removed prior to

installing the hood. For 90° hoods, separate louvers will

ship with the hood assembly. To remove the spring

loaded louver blades, grasp the blade and apply

pressure against the louver blade retaining spring. After

compressing the spring, the tab on the opposite side of

the blade can be removed from the unit, freeing the

blade from the unit.

Note: Do not lose the louver blade retaining springs as they

will be required later to install the blades into the hood

assembly.

Summary of content (4 pages)

PAGE 1
-660.0 5H0827900000 August, 2019 INSTALLATION INSTRUCTIONS 30°, 60°, and 90° downward deflector hoods LodronicTM Models HCH – ACCESSORY DOWNWARD DEFLECTOR HOOD Deflector Hood Model Application The 30°, 60° and 90°, Downward Deflector Hoods are designed for use on LodronicTM hydronic unit heaters. Assembly/Installation IMPORTANT 1. The use of this manual is specifically intended for a qualified installation and service agency.
PAGE 2
Figure 2.1 - Hood Exploded View 1. Install the hood hangar bracket to the top interior surface of the unit opening (see figure 2.2), using the #10 x ½” self drilling screws provided. Dimples located at the top of the opening will provide locating points to secure the bracket. Once the bracket is installed, ensure that there is a small gap between the hangar bracket and the front face of the unit. A screwdriver or similar tool may be required if adjustment needs to take place to create a gap. Figure 2.
PAGE 3
INSTALLATION – VERTICAL DEFLECTOR BLADES Figure 2.3 – Placing Hood on Unit 7. Figure 2.5 – Completed Hood Assembly Grasp the hood assembly by the bottom panel or through the opening. Lifting it slightly above the opening of the unit, press the flanged surface of the hood against the front panel of the unit. Using caution, slowly lower the hood so that the lip of the top panel drops into the gap between the hangar bracket (installed in step 2) and the front face of the unit. The hood is now secure.
PAGE 4
Modine Manufacturing Company 1500 DeKoven Avenue Racine, WI 53403 Phone: 1.800.828.4328 (HEAT) www.modine.com  Modine Manufacturing Company 2019 1-660.