OHP Installation Manual

10
OHP Series
2.0 Installation • Heater Mounting • Optional Mounting Kit
Heater Mounting
The heater shall be mounted in a fixed position attached from a structure that can evenly support the total
force and weight of the heater. The mounting means shall be independent of the gas and electrical supply
line. All hangars and bracket material shall be of noncombustible construction. Examples of suitable material
include, but are not limited to, steel channel, steel tubing, threaded rod, or field fabricated hangers that are
adequate to bear the load. In some cases, the heater may need to be isolated from vibration with the use of
vibration isolating devices.
The heater must be level from side to side and can be set at an angle between 0° and 30° from horizontal.
Figure 2.1 • Heater Dimensions
Optional Mounting Kit
Optional adjustable mounting kits and brackets are available for the Patio Heater. Refer to the insert that
was packaged with the mounting brackets for complete installation instructions.
WARNING
!
Improper suspension of the infrared heater may result in collapse and persons being crushed.
Always suspend from a permanent part of the building structure that can support the total
force and weight of the heater.
Failure to maintain minimum clearance to combustibles may result in fire and/or explosion,
property damage, serious injury, or death. Always maintain minimum clearances and post
signs or provided tags (F/N: LL01) where needed. Signs should state the hazards for the
particular application and be legible for the building occupants. Consult the factory or a
factory representative for additional information on signage compliance.
END VIEWSIDE VIEW
2.75”
10.875”
9”
48.375”
9”