COMMERCIAL & INDUSTRIAL UNITARY HEATING PRODUCTS GAS STEAM/HOT WATER OIL ELECTRIC 75-136.
MODINE COMMERCIAL & INDUSTRIAL UNIT HEATERS Modine has always been the industry standard for comfort heating applications. With the Modine product line, you can fulfill your unit heater application needs with a variety of energy sources. Natural or Propane Gas • Steam/Hot Water • Oil • Electric Modine sales representatives are experienced specialists in the engineering, selection and application of Modine commercial and industrial heating and ventilating equipment.
UNITARY HEATING PRODUCTS - TABLE OF CONTENTS CONTENTS PAGE Gas-Fired Unit Heaters, Indoor Duct Furnaces, Infrared Heaters Power-Exhausted.................................................................................. 4 Separated Combustion............................................................................ 5 Separated Combustion, High-Efficiency Condensing........................... 6-7 Blower Models.......................................................................................
TAPE OUT GAS-FIRED, POWER-EXHAUSTED • 82% Thermal Efficiency • Horizontal or Vertical Venting • Field Convertible to Propane • 100% Shut-Off with Continuous Retry • Commercial or Residential Applications MODEL HD For applications requiring a low profile unit, Modine offers the Hot Dawg® unit heater. The Hot Dawg® may be installed in residential or commercial applications just one inch below the ceiling.
GAS-FIRED, SEPARATED COMBUSTION • 100% Outside Air for Combustion • Sealed Compartment Protects Combination Gas Control, Ignition Control, Manifold and Burner • Horizontal or Vertical Concentric Venting • 82% Thermal Efficiency • Direct Spark Ignition • 100% Shut-Off with Continuous Retry • Certified for Commercial or Residential Applications The separated combustion models HDS/HDC and PTS/BTS draw 100% of their combustion air from outside to ensure that the unit will always have plenty of fresh, clean air
GAS-FIRED, SEPARATED COMBUSTION, HIGH-EFFICIENCY CONDENSING • 100% Outside Air for Combustion • Sealed Compartment Protects Combination Gas Control, Ignition Control, Manifold and Burner • Conservicore® Secondary Heat Exchanger • Horizontal or Vertical Concentric Venting • Up to 97% Thermal Efficiency • Direct Spark Ignition • 100% Shut-Off with Continuous Retry MODEL PTC MODINE CONSERVICORE® HEAT EXCHANGER Up to 97% thermal efficiency for all model sizes, Modine’s Effinity® condensing unit heater featur
GAS-FIRED, SEPARATED COMBUSTION, HIGH-EFFICIENCY CONDENSING Figure 7.1 - U.S. Average Heat Load Hours Map Use 3500 for Alaska and Canada. Table 7.1 - Estimated Annual Fuel Cost Savings Using the Effinity Condensing Unit Heater Estimated Annual Savings Against Other Equipment ➀ ➁ Gravity Vented Design Heat Load (Btu/Hr): Annual Heat Load Hours (refer to Figure 7.
GAS-FIRED, BLOWER MODELS Blower unit heaters are designed for both heating and ventilating. All Modine gas-fired unit heater types can be equipped with blowers, including our Hot Dawg® low-profile residential garage heaters and the Effinity®. In fact, the Effinity® is the only high efficiency gas-fired unit heater in North America with this option available. MODEL HDB These units can be used in a variety of ways: • Ducting air in from adjacent spaces for ventilation.
GAS-FIRED, GRAVITY AND POWER-VENTED DUCT FURNACES • Low Initial Cost • Applications Cover Heating and/or Make-Up Air • 75,000 to 400,000 Btu/Hr Input Capacity • 82% Minimum Thermal Efficiency • Low Maintenance • Easy to Service The Modine indoor duct furnace was designed for use with a building’s heating, heating/ cooling and make-up air systems. Available in 11 model sizes, in both gravity and power vented configurations, the unit covers a wide variety of applications.
GAS-FIRED, HIGH-INTENSITY INFRARED UNITS • 30,000 to 200,000 Btu/Hr Input • Simple Chain Mounting • High Heat Transfer Ceramic Tiles • Unvented Operation • Low Installation Cost • Ideal for Spot Heating • Available in Natural or Propane Gas Modine’s high-intensity ceramic infrared heater is approved for indoor unvented installation. It does not utilize a fan, thus eliminating noise and draft distractions.
GAS-FIRED, HIGH-INTENSITY INFRARED UNITS • 31,000 to 34,000 Btu/Hr Input • Simple Bracket Mounting • High Heat Transfer Ceramic Tiles • Unvented Operation • Low Installation Cost • Available in Natural or Propane Gas Modine’s high-intensity ceramic Patio infrared heater is approved for indoor and outdoor residential or commercial applications. It does not utilize a fan, thus eliminating noise and draft distractions.
GAS-FIRED, LOW-INTENSITY INFRARED UNITS • Pressurized Type, Low-Intensity Heater • 50,000 to 200,000 Btu/Hr Input • 20 to 70 Foot System Lengths • Straight and U-Shaped Configurations • Simple Chain Mounting • Designed for Indoor or Outdoor, Vented or Unvented, Commercial and Industrial Installation • Available in Natural or Propane Gas Modine’s single-burner positive pressure infrared heater is approved for vented or unvented commercial and industrial applications.
HOT DAWG H2O® - LOW PROFILE HOT WATER UNIT HEATER • Low Profile Design • Available in Two Model Sizes • Side Access Piping and Electrical Connections • Flexible Mounting Orientations • Attractive Hammertone Beige Powdercoat Paint Finish • High Capacity Two-Row Hot Water Coil • Twin Blower Wheels MODEL HHD For applications requiring a low profile unit, Modine offers the Hot Dawg H2O® hot water unit heater.
STEAM/HOT WATER, HORIZONTAL DELIVERY UNIT HEATERS • Totally-Enclosed Motor • Thermal Overload Protection • Adjustable Horizontal Blades • Top/Bottom (Model HSB) or Side (Model HC) Inlet/Outlet Piping • Fan Safety Guard • High Air Velocity Models PT/PTN An industry leader since Arthur B.
STEAM/HOT WATER, VERTICAL DELIVERY UNIT HEATERS • 15 Standard Models • Lightweight, Easy to Install • Totally-Enclosed Motors • 33,000 to 952,000 Btu/Hr Input • Built-In Fan Safety Guard Modine model V/VN vertical steam/hot water unit heaters are designed for long heat-throw, uniform comfort heat delivery, and reduced maintenance. The units are recommended for areas where ceilings are high or where obstructions do not permit good horizontal movement of air.
OIL-FIRED, HORIZONTAL DELIVERY UNIT HEATERS • Three Sizes • Pressure-Atomizing, Gun-Type Oil Burner • Cad-Cell Safety Shut-Off • Electric-Spark Ignition • Fan and Limit Control Modine model POR oil-fired unit heaters are built with time-tested and field-proven components to provide optimum comfort and heating efficiency as high as 84%. MODEL POR Standard features include: •A long-life heat exchanger is made of corrosion-resistant, aluminized steel and rollformed to eliminate thermal stress.
ELECTRIC, HORIZONTAL VERTICAL DELIVERY UNIT HEATERS • Low Installation Cost and Maintenance • Model VE Available in 21 Models, 9 Sizes from 5k W through 50 kW • Model HER Available in 8 Sizes from kW through 25kW • High-Capacity Unit with Horizontal Air Delivery • Model PTE Available in 3 Sizes from 15kW through 50 kW • Model PTE and VE Offered in Single and Two-Stage Controls Modine electric unit heaters provide a wide variety of options in solving comfort-heating problems.
ELECTRIC, HAZARDOUS LOCATIONS UNIT HEATERS • Rated for 100,000 Cycles of Service • UL Listed • Sealed Heat-Exchanger Core • Ethylene Glycol for Heat Transfer Fluid • Protected, Explosion-Proof Electric Motor • Two-Piece Fan-Guard Modine’s HEX electric unit heaters are designed for hazardous industrial locations where potential for explosion exists due to the presence of flammable gases, vapors, powdered-metals or dusts.
MODINE BREEZE® ACCUSPEC SIZING AND SELECTION PROGRAM • With the Modine AccuSpec Program, Equipment Selection is a Breeze® The Modine Breeze® AccuSpec is the fastest way to generate performance data based on actual job conditions. The Breeze AccuSpec program is a Web-based sizing and selection program. The program provides a series on step-by-step questions that allow for the easy configuration of Modine products.
HISTORY A.B. Modine founded Modine Manufacturing Company in 1916 as a one-room office adjacent to a small workshop in Racine, WI. Today, Modine is an integral part of the world marketplace with sales approaching $1.5 billion. It specializes in products used in industrial heating, ventilation and air conditioning equipment, light, medium and heavy-duty vehicles, off-highway and industrial equipment and refrigeration systems.
THIS PAGE INTENTIONALLY LEFT BLANK Request Catalog 5-157 For Complete Technical Information and Specifications. 75-136.
THIS PAGE INTENTIONALLY LEFT BLANK Request Catalog 5-157 For Complete Technical Information and Specifications. 22 75-136.
THIS PAGE INTENTIONALLY LEFT BLANK Request Catalog 5-157 For Complete Technical Information and Specifications. 75-136.
Products from Modine are designed to provide indoor air-comfort and ventilation solutions for residential, commercial, institutional and industrial applications.
