Instructions

Manual MODSTER ROOKIE
www.modster.at 13
2. Plug the ESC to the battery cable to switch ESC
on.
5. Use the steering trim dial to adjust the neutral position of the servo.
Push the dial counter-clockwise to trim left, clockwise to trim right,
until your vehicle tracks straight when steering at neutral position.
4. Rotate the wheel counter-clockwise to turn left. Rotate the wheel
clockwise to turn right.
6. If the direction of travel on the rudder is
opposite, slide the steering reverse switch to
the other position.
WARNING: Do NOT slide the throttle reverse
switch unless you completely understand
this function and it is necessary to switch.
Otherwise serious damage may occur.
3. To slowly drive forward, pull the throttle trigger slightly. Adjust the speed by pul-
ling the trigger. Push the trigger to brake/reverse. Release the trigger to keep your
vehicle still.
Steering Trim
Trimmer
Switch Up/Down for
Larger/Smaller Servo Angle
Throttle Reverse Switcher
Steering Reverse
Switcher
Switch Up/Down for
Larger/Smaller Servo Angle
Dual rate
8. After you  nished, turn o ESC
power, then unplug battery and put
in a dry safe place to cool down befo-
re you use it again.
7. Adjust the servo angle by turning the switch
up or down.
Turn the switch to upper position for larger ser-
vo angle.
Turn the switch to lower position for smaller ser-
vo angle.
Put 4 pcs mignon AA batteries* in the
transmitter & take care of the polarity!
*not included
Slide the switch
UP for ON and
DOWN for OFF
Solid LED light:
Battery is in good
condition (Above
4.3V)
Flashing LED:
Battery is at low
voltage
Replace batteries
7. How-to-start Guide