Instructions

Manual MODSTER ROOKIE
www.modster.at 13
2. Connect the battery to the controller to switch it
on - an LED now lights up.
5. Use the steering trim dial to adjust the neutral position of the servo.
Push the dial counter-clockwise to trim left, clockwise to trim right,
until your vehicle tracks straight when steering at neutral position.
4. Rotate the wheel counter-clockwise to turn left. Rotate the wheel
clockwise to turn right.
6. If the direction of travel on the rudder is
opposite, slide the steering reverse switch to
the other position.
WARNING: Do NOT slide the throttle reverse
switch unless you completely understand
this function and it is necessary to switch.
Otherwise serious damage may occur.
3. To slowly drive forward, pull the throttle trigger slightly. Adjust the speed by pul-
ling the trigger. Push the trigger to brake/reverse. Release the trigger to keep your
vehicle still.
Steering Trim
Trimmer
Switch Up/Down for
Larger/Smaller Servo Angle
Throttle Reverse Switcher
Steering Reverse
Switcher
Switch Up/Down for
Larger/Smaller Servo Angle
Dual rate
7. Adjust the servo angle by turning the switch 8. After driving, disconnect the battery from
the controller and let it cool down before
charging.
Never charge or store the battery in the
model!
up or down.
Turn the switch to upper position for larger ser-
vo angle.
Turn the switch to lower position for smaller ser-
vo angle.
Put 4 pcs mignon AA batteries* in the
transmitter & take care of the polarity!
*not included
Slide the switch
UP for ON and
DOWN for OFF
Solid LED light:
Battery is in good
condition (Above
4.3V)
Flashing LED:
Battery is at low
voltage
Replace batteries
7. How-to-start Guide