manual

Seite 15
When switching between modes one and two it is necessary to reverse the gimbals positions to ensure
that throttle is on the correct side. To switch the sticks:
1. Take the battery out from the transmitter, Loosen the four screws that hold the rear cover shown in
green on left .
2. Carefully take the back off the transmitter and disconnect the cables connected to it.
3. Unscrew the screws around the gimbals, marked in green in the picture on right.
4. Switch the gimbals to the opposite side. Make sure the gimbals have been rotated 180 degrees so
that the wires are facing towards the middle of the system.
5. Reconnect the wires connecting the back to the front, then reattach the back and tighten the screws.
4.5 Power Off