manual

Seite 21
5.13 Throttle Hold
This function is used with gas powered models in order to stop stalls when not in use.
Setup:
1. Use the "OK" key to change between settings.
2. Use the "UP" and "DOWN" keys to turn the function on or
off and increase and decrease the hold percentage.
3. To return a setting to default, press and hold the "OK" key
for 3 seconds . Press and hold the "CANCEL" key to save.
This function will not work unless assigned to a switch. The switch can be used to enable or disable
the function. Please refer to [5.12 Assign Switches] for more details on how to assign a switch to a
function.
Switches must be turned on in the [7.13 Aux Switches] function to be available for assignment.
Note This function must be assigned to a switch in the Switches assign function.
6. Helicopter Functions
6.1 Pitch Curve
The pitch curve function is for programing the response of the helicopters blades collective pitch, which
controls the amount of lift the helicopter has. This functions output is shown on the graph, with points
along the bottom (L,1,2,3,H), and collective pitch up the side (0-100%). When the throttle stick is moved
its position will be shown in real time.
Setup:
1. Use the "OK" key to cycle bet ween point s.
2. Use the "UP" and "DOWN" keys to change the percentage (All changes are shown in real time in the
graph)
3. To return to default settings press and hold the "OK" key for 3 seconds, press and hold the "CANCEL"
key to save.
6.2 Swashplate Mix
The swashplate mix function sets the relative movement between each servo controlling movement of the
swash plate controlling aileron, elevator and pitch.
Setup:
1. Press the "OK" key to cycle through aileron, elevator and pitch.
2. Use the "UP" and 'DOWN" keys to change the percentage.
3. Press and hold the "CANCEL" key to save and exit.
4. To return to default settings press and hold the "OK" key until the currently selected parameter returns
to 50%, and press and hold the "CANCEL" key to save.