manual

Seite 22
6.3 Gyroscope
The gyroscope function uses a gyroscope to correct for torque produced by changes in engine speed, pitch
and wind etc., which can cause issues with yaw control. If not corrected each of these variables could
cause the RC helicopter to spin, sometimes quite violently.
This function has 2 settings, Gyro (On/Off) and Value (%). The Mode shows the state of the idle up
function (Please note, this function needs to be assigned to a switch).
Setup:
1. Use the "OK" key to cycle bet ween "Gyro" and "Value" , select "Gyro" and press the "UP" or "DOWN"
key to toggle on or off.
2. Select "Value" and up the "UP" and "DOWN" arrow keys to change the percentage.
3. To return to default settings press and hold the "OK" key until the currently selected parameter returns
to 50%, and press and hold the "CANCEL" key to save.
7. System
7.1 Model Select
Use this function to select stored models, use the "UP" and "DOWN" keys to choose a model and press
and hold the "CA NCEL" key to save and exit. The system can store up to 20 models.
7.2 Model Name
This function renames the currently selected model.
Setup:
1. Use the "UP" and "DOWN" keys to select a letter or number, then press the "OK" key to confirm.
2. To save press and hold the "CANCEL" key.
To return to default press and hold the "OK " key for 3 seconds, press and hold the "CANCLE" key to save.
7.3 Type Select
This function changes the type of the currently selected model, including airplane and helicopter with
different types of swashplates.
1
I
I
I
!
Setup:
1. To change the model type press the "UP" and "DOWN" keys to select the model type, then press and
hold the "CANCEL" key to save and exit.
7.4 Model Copy
This function copies the one model to another model slot.
Swash 1 40°
Pitch Curve , Swashplate Mix , Gyroscope
Swash 12 0°
Pitch Curve , Swashplate Mix , Gyroscope
Swash 90°
Pitch Curve , Swashplate Mix , Gyroscope
Variable pitch
Pitch Curve , Gyroscope
1Fixed pitch
Gyroscope