manual

Seite 24
3. To return to default settings press and hold the "OK" key for 3 seconds, press and hold the "CANCLE"
key to save.
7.10 Firmware Version
This function displays the current firmware version.
7.11 Firmware Update
This function updates the firmware using a USB to PS/2 connection lead.
Setup:
1. First download the update from our website, http://www.modster.at.
2. Connect the system to the computer via the supplied cable and press "OK" while in this function.
3. Wait for windows to recognize the system.
4. Then open the update on the computer and press update.
5. Once the update is finished cycle the system power.
7.12 Factory Reset
This function resets the entire system back to its factory settings.
Tore set press "OK", then use the "UP" and "DOWN" keys to select Yes and press 'OK" again.
7.13 Aux Switches
This function both activates and deactivates switches/knobs as well as changing the amount of active
channels the system will use. This is usually done when a new switch or knob has been.
Setup:
1. Use the "OK" key to cycle through the selection of switches and knobs.
2. Use the "UP" and "DOWN" keys to turn the selected switch/knob on or off.
3. Keep pressing the "OK" key until "Ch" is selected.
4. Use the "UP" and "DOWN" keys to change the amount of active channels to match your current
configuration.
5. To return to default settings press and hold the "OK" key for 3 seconds, press and hold the "CA
NCLE" key to save.