manual
Seite 25
!
_!_
Note
8.
RX Setup
8.1
RF Standard
This menu allows you to change the communication protocol for the transmitter. The available protocols
are:
RF Protocol
AFHDS
Reiceiver
1
R9B,R6B,R6C,GR3E,GR3F
AFHDS 2A
A3, A6,X6, iA4B, iA6, iA6B, iAl0, iAl0B
1
To Switching Between AFHDS 2A and AFHDS:
First navigate to the system menu by pressing and holding the "OK" key until the main menu opens, select "System
Setup" by pressing the "OK" key again .
1.
Use the "DOWN" key to navigate to "RX setup" and press the "OK" key again to enter, then press the
"OK" key one more time to select RF Standard.
2.
The system will display a prompt asking if you are sure, use the "UP" or "DOWN" key to select yes and
press "OK".
3.
Then use the "UP" or "DOWN" key to select the desired RF standard and press and hold the "CANCEL"
key for until the system returns to the previous menu to save.
4.
Use the "UP" and "DOWN" keys to select a mode then press and hold the "CANCEL" key to save and
exit.
8.2
RX Battery
This function is used to change the battery monitor settings. This function can be switch to an external or
internal sensor.
There are 4 settings:
[External sensor/ Internal Sensor]: The system has its own voltage sensor however it is possible to change
to an external sensor.
[Low]: Sets the low battery voltage, see your batteries user manual to set this setting.
[Alarm]: Sets the voltage level at which the system will alert the user if the battery gets too low.
[High] : Sets the voltage for the battery if it is full.
These settings affect how the system shows battery levels, if the high and low
are incorrect the systems battery display will not be reliable.
8.3
Failsafe
This function is used to protect the models and users if the receiver loses signal and therefore is no
longer controllable.
All channels are listed in the failsafe menu. [Off] means that in case of a lass of signal, the corresponding
servo will keep its last received position. If it displays a percentage, the servo will instead move to the
selected position .
Setup:
1.
Use the "UP" and "DOWN" to choose a channel and press "OK" to enter its failsafe settings.
2.
Use the "UP" and "DOWN" to turn the failsafe on or oft.
3.
Move the channels control surface to the desired position and hold the "CANCEL" key to confirm and
exit.