manual

Seite 28
9. System Customization
The MODSTER XC-6 switches and knobs can be
moved to other channels. Or if using receivers with
more channels, the system can be expanded with
extra switches or knobs.
By default, from left to right, the knobs are channels
5 and 6, the switches are 7, 8, 9 and 10.
IFS- A6/ FS-i A6B/ FS-iA 6
l6CH
IFS-iAl0B 16-l0CH
9.1 Switching Channel Assignments
To change a switch or knobs channel, the system
must be taken apart. The first step is taking the back
cover off.
1. Remove any batteries from the system and
replace the battery cover.
2. Remove the screws marked in green.
Make sure the screw driver
you are using is not too big
_!_ Note
or too small. Failure to do
so could damage the head
of the screw.
3. Carefully pry the front and back apart, this may
take some force.
_!_ Note
Don't pull the pieces too
far apart , doing so could
damage cables attacking the
front and back together.
4. Carefully disconnect the cables connecting the front to the back.
_!_ Note
_!_ Note
_!_ Note
Make sure you keep the screws in a safe place.
Make sure that the wires are fitted along beside each of the gimbals as show
right.
Make sure that all switches are installed with the correct orientation shown
right.