manual

Seite 29
5. On the circuit board each channel is labeled, making it easy to find the correct channel. Follow the
cables leading from each connector to identify which switch or knob goes to each channel.
6. Carefully remove the desired connectors from the board.
Do not pull on the wires themselves, doing so may damage the connector or
wire.
7. Replace the desired switch/knob connectors into the corresponding channel slot.
Setup:
1. Take the transmitter apart following the above instructions.
2. Remove the toggles connector from the circuit board.
3. Unscrew the plate holding the toggle in place on the front of the transmitter.
Removing a knob:
Remove the pot cover by slowly pulling on it, it should come off without much effort.
1. Remove the 4 screws located on the back of the system and remove the back cover.
2. Follow the knobs wire and disconnect it form the board.
3. Gently remove the knob cap by pulling it up.
4. Remove the nut holding the knob in place.
5. Remove knob.
8. Put the back cover back in place, and squeeze the handle until the two pieces click together.
9. Replace the cover screws.
Note