Instructions/Manual Easy Trainer 800 V2

Manual MODSTER Easy Trainer 800
22 www.modster.at
6. Charging the ight battery
The enclosed charger is used to safely charge LiPo batteries.
ATTENTION: Please follow all safety instructions from ALL enclosed instructions for use and safety data sheets exactly! All instructions must be
taken seriously, failure to do so may result in re, chess damage or even injury.
Battery warning:
- By handling, such as charging/discharging/use as well as storage, you assume the risk that exists for LiPo batteries.
- If the battery starts to swell, immediately stop the activity you are carrying out.
- Store the battery at room temperature in a dry environment. Do not store in a car and do not expose to direct sunlight.
- Charge LiPos only with designated chargers for LiPo batteries.
- Do not discharge below 3V/cell.
- Do not charge unattended and never charge damaged batteries.
- Never charge or store the battery in the model!
Charging process:
The AC-3510 charger is supplied with the kit for this model. Please read the following instructions carefully. Place the battery on a reproof
surface for charging and charge it outside the model! Only use pre-charged batteries for range tests and binding processes.
Parameter Minimal Normal Maximum Unit
Input voltage:
100-240 AC Volt
Working temperature: -20 45 °C
Storage temperature: -20 65 °C
Charging end voltage: 4,19 4,20 4,21 Volt
Charging current: 1000 mA
Balancer current: 10 10 mA