Instructions/Manual Easy Trainer 1280 V2
Manual MODSTER Easy Trainer 1280 V2
www.modster.at 25
6. Charging the ight battery
The enclosed charger is used to safely charge LiPo batteries.
ATTENTION: Please follow all safety instructions from ALL enclosed instructions for use and safety data sheets exactly! All instructions must be
taken seriously, failure to do so may result in re, chess damage or even injury.
Battery warning:
- By handling, such as charging/discharging/use and storage, you assume the risk that exists for LiPo batteries.
- If the battery inates, immediately interrupt the activity you are currently carrying out.
- Store the battery at room temperature in a dry environment. Do not store in a car and do not expose to direct sunlight.
- Charge LiPos only with designated chargers for LiPo batteries.
- Do not discharge below 3V/cell.
- Do not charge unattended and never charge damaged batteries.
- Never charge or store the battery in the model!
Charging process:
The AC-3S10 charger is supplied with the kit for this model. Please read the following instructions carefully. Place the battery on a reproof
surface for charging and charge it outside the model! Only use pre-charged batteries for range tests and binding processes.
Parameter Minimal Normal Maximum Unit
Input voltage:
100-240V AC Volt
Working temperature: -20 45 °C
Storage temperature: -20 65 °C
Charging end voltage: 4,19 4,20 4,21 Volt
Charging current: 1000 mA
Balancer current: 10 10 mA