Instructions/Manual Easy Trainer 1280 V2

Manual MODSTER Easy Trainer 1280 V2
40 www.modster.at
13.1 Basic parameters
1. designed for xed-wing models, multicopters and ground vehicles
2. transmission power: less than or equal to 70mW
3. transmission frequency: 2420 MHZ---2459 MHZ
4. ground control range: greater than 300 metres
5. transmitter power supply requirements: DC+6V (4 AA batteries)
6. receiver power supply requirements: DC+6V
13.2 Quick guide for transmitter and receiver
1. switch o the transmitter, connect the signal line of the controller to the third channel of the receiver and
then connect the battery to the controller.
2. the orange status light ashes slowly when the receiver is switched on.
3. press the binding switch with a small pointed object - the orange status light will ash quickly.
4. return the throttle to the lowest position and switch on the transmitter. Once the transmitter and receiver
are paired, the status light on the receiver will be solid.
5. switch o the entire system, connect all servos according to the ight manual. Make sure the polarity of
each connector is correct.
6. Move each control stick and check that the servos respond in the correct direction.
7. Repeat the previous steps if the system does not work properly.
*Note: The M. Bus channel is connected to the ight controller via a servo harness.