operation manual

Manual MODSTER XC Maximum

20 www.modster.at

7. How-to-Start Guide:

Necessary tools:

• Hobby Knife

• Precision ruler

• Needle nose pliers

• Lexan scissors (279582)

• Flat and Philips screwdriver (287644)

• Wire cutters

• Cross wrench-Set (279577)

• CA glue & rubber cement-Set (12176)

• Thread locking compound-Set (52622)

• Hex wrench (279576)

• 4 pcs AA Mignon batteries for the transmitter (280555)

Tire assembly

When installing the wheels, rst tighten the wheel nuts tightly and check the smooth running of the wheels.

Then loosen the wheel nuts until the wheels turn smoothly.

Stepwise wheel mounting:

• Insert the safety pin through the bore of the shaft

• Place the 6-pin wheel carrier on the pin

• Put on the wheel

• Put on the safety disc

• Tighten nut

Important notice: Be sure to unhitch the model during the initial start-up so that the wheels can rotate freely and the adjustments on the

transmitter can be carried out without any problem.