Installation Manual

Customer Service 908-368-1025︱www.modwayfurniture.com Page 1 of 2

EEI -1178/1179/1136/1137 CHAIR /LOVESEAT

Hardware:

Component:

Bolt x 8

Allen Wrench x 1

Chair or Loveseat Body x1

Leg x4

Thank you for purchasing the MODWAY CHAIR/LOVESEAT!

Before you start, here is some helpful advice:

1.We suggest you spend a short time reading through this leaflet and then follow the simple step by step

instructions.

2.Owing to the size and weight of the chair/loveseat, we recommend that it is assembled by two adults, on a

carpeted or padded area, in the room that it is intended for. Approximate assembly time: 30 minutes.

3.Please do not use any tools other than those provided or recommended in these instructions.

4.Please do not throw away any of the packaging or instructions until you have checked all the components and

hardware and the furniture is fully assembled.

5.Assemble all components loosely until advised to tighten. Depending on use, it may be necessary to tighten the

components from time to time, so please save the tools that have been provided.

6.Please keep all pieces out of reach of small children.

Spring Washer x 8

Flat Washer x 8

PAGE 1
EEI -1178/1179/1136/1137 CHAIR /LOVESEAT Thank you for purchasing the MODWAY CHAIR/LOVESEAT! Before you start, here is some helpful advice: 1.We suggest you spend a short time reading through this leaflet and then follow the simple step by step instructions. 2.Owing to the size and weight of the chair/loveseat, we recommend that it is assembled by two adults, on a carpeted or padded area, in the room that it is intended for. Approximate assembly time: 30 minutes. 3.
PAGE 2
EEI -1178/1179/1136/1137 CHAIR /LOVESEAT STEP 1: Please find the package of Legs (2) and hardware on the top of the seat. Then put the Chair or Loveseat Body (1) upside down on a carpeted or padded area by two adults to make fully visible the corners. Position one of Legs (B) at one of the four wooden corners. Insert 2 pieces of Spring Washer (B), Flat Washer (C) into 2 pieces of Bolts (A) as shown. Then insert assembled 2 pieces of Bolts (A) into the corner to connect the Leg (2).