User Manual

Customer Service 908-368-1025︱www.modwayfurniture.com Page 1 of 2

EEI –147

CHAIR

Hardware:

Component:

Bolt M6x15mm x 4

Chair Body x1

Chair Base x1

Plastic Washer x 4

Spring Washer M6 x 4

Thank you for purchasing the MODWAY CHAIR！

Before you start, here is some helpful advice:

1.We suggest you spend a short time reading through this leaflet and then follow the simple step-by-step

instructions.

2.Owing to the size and weight of the chair, we recommend that it is assembled by two adults, on a carpeted or

padded area, in the room that it is intended for. Approximate assembly time: 30 minutes.

3.Please do not use any tools other than those provided or recommended in these instructions.

4.Please do not throw away any of the packaging or the instruction until you have checked all the components and

hardware and the furniture is fully assembled. Please ensure that the packaging is disposed of in a safe and

environmentally friendly way.

5.Assemble all components loosely until advised to tighten. Depending on use, it may be necessary to tighten the

components from time to time, so please save the tools that have been provided.

6.Please keep all fitting out of reach of children.

Flat Washer M6 x 4

Allen Wrench M4 x 1

PAGE 1
EEI –147 CHAIR Thank you for purchasing the MODWAY CHAIR！ Before you start, here is some helpful advice: 1.We suggest you spend a short time reading through this leaflet and then follow the simple step-by-step instructions. 2.Owing to the size and weight of the chair, we recommend that it is assembled by two adults, on a carpeted or padded area, in the room that it is intended for. Approximate assembly time: 30 minutes. 3.
PAGE 2
EEI –147 CHAIR STEP 1: Please put Chair Body (1) upside down on a carpeted or padded area. Place Chair Base (2) to Chair Body (1) as shown. Insert 4 pieces of Bolt (A) with 4 pieces of Spring Washer (B) and 4 pieces of Flat Washer (C) through the holes on 4 pieces of Plastic washer (D) and Chair Base (2) into the holes on bottom of Chair Body (1) as shown. Use Allen Wrench (E) to tighten all Bolts (A) clockwise until secure.