Instructions / Assembly

Customer Service 908-368-1025︱www.modwayfurniture.com Page 2 of 2
EEI-2247 SUNBED
1
2
3
bottom of back leg
bottom of lounge back
3
2
A
C
C
Ax4 Bx4 Cx1
STEP 1:
Remove the plastic covers which pre-install in the end of side rail on the Lounge Back(2) by using Allen Wrench (C).
Insert Lounge Back (2) into Back Leg (3) as shown by two adults.
Insert 2 pieces of Bolt (A) from the pre-drilled holes on the bottom of the Lounge Back (2) into each side
on the bottom of Back Leg (3).
Insert 2 pieces of Bolt (B) from the pre-drilled holes on the side rail of the Lounge Back (2) into each end of Back Leg (3) as shown.
Do not fully tighten Bolts (A&B) at this step.
Repeat the same steps for Front Leg (1).
After checking the leveling for all connections, please use Allen Wrench (C) to tighten all Bolts (A&B) clockwise until secure.
Hardware & Tool required
STEP 2:
Assembly is completed. The bed is ready to enjoy now!
Carefully place the assembled bed at your desired position.
B