Instructions / Assembly

Customer Service 908-368-1025︱www.modwayfurniture.com Page 1 of 2

EEI-2267 ARM LOVESEAT

Hardware:

Component:

Bolt M6x20mm x4

Allen Wrench M4 x1

Top Rail x1

Thank you for purchasing the MODWAY ARM LOVESEAT！

Before you start, here is some helpful advice:

1.We suggest you spend a short time reading through this leaflet and then follow the simple step by step

instructions.

2.Owing to the size and weight of the loveseat, we recommend that it is assembled by two adults, on a carpeted or

padded area, in the room that it is intended for. Approx assembly time: 30 minutes.

3.Please do not use any tools other than those provided or recommended in these instructions.

4.Please do not throw away any of the packaging or the instruction until you have checked all the components and

hardware and the furniture is fully assembled. Please ensure that the packaging is disposed of in a safe

environmentally friendly way.

5.Assemble all components loosely until advised to tighten. Depending on use, it may be necessary to tighten the

components from time to time, so please save the tools that has been provided.

6.Please keep all fitting out of reach of children.

Bolt M6x25mm x6

Left Leg x1

Right Leg x1

Seat Frame x1

Seat Cushion x2

Back Cushion x2

PAGE 1
EEI-2267 ARM LOVESEAT Thank you for purchasing the MODWAY ARM LOVESEAT！ Before you start, here is some helpful advice: 1.We suggest you spend a short time reading through this leaflet and then follow the simple step by step instructions. 2.Owing to the size and weight of the loveseat, we recommend that it is assembled by two adults, on a carpeted or padded area, in the room that it is intended for. Approx assembly time: 30 minutes. 3.
PAGE 2
EEI-2267 ARM LOVESEAT STEP 1: Remove the plastic covers which pre-install in the end of the Seat Frame (4) by using Allen Wrench (C). Please put the Left Leg (2) on a carpeted or padded area. Insert Top Rail (1) and Seat Frame (4) into Left Leg (2) as shown. Insert 3 pieces of Bolt (B) from the pre-drilled holes on the bottom of the Top Rail (1) and Seat Frame (4) into each side on the bottom of Left Leg (2).