Instructions / Assembly

Customer Service 908-368-1025︱www.modwayfurniture.com Page 1 of 3

EEI–2706 LOUNGE

Hardware:

Component:

Bolt M6x70mm x 6

Lounge Seat x1

Thank you for purchasing the MODWAY LOUNGE!

Before you start, here is some helpful advice:

1.We suggest you spend a short time reading through this leaflet and then follow the simple step by step

instructions.

2.Owing to the size and weight of the lounge, we recommend that it is assembled by two adults, on a

carpeted or padded area, in the room that it is intended for. Approximate assembly time: 30 minutes.

3.Please do not use any tools other than those provided or recommended in these instructions.

4.Please do not throw away any of the packaging or instructions until you have checked all the components and

hardware and the furniture is fully assembled.

5.Assemble all components loosely until advised to tighten. Depending on use, it may be necessary to tighten the

components from time to time, so please save the tools that have been provided.

6.Please keep all pieces out of reach of small children.

Left Frame x1

3 Right Frame x1

Allen Wrench M4 x 1

Top Rail x1

Back Cushion x1

7 Seat Cushion x1

Back Rail x2

PAGE 1
EEI–2706 LOUNGE Thank you for purchasing the MODWAY LOUNGE! Before you start, here is some helpful advice: 1.We suggest you spend a short time reading through this leaflet and then follow the simple step by step instructions. 2.Owing to the size and weight of the lounge, we recommend that it is assembled by two adults, on a carpeted or padded area, in the room that it is intended for. Approximate assembly time: 30 minutes. 3.
PAGE 2
EEI–2706 LOUNGE STEP 1: Please put Left Frame (2) on a carpeted or padded area. Insert the tenon on Lounge Seat (1) into the rabbet on Left Frame (2) at first. Then insert the tenon on Lounge Seat (1), Top Rail (4) and Back Rails (5) into the rabbet on Left Frame (2) as shown. 5 5 4 1 2 STEP 2: Carefully position Right Frame (3) to the assembled Lounge Seat (1), Left Frame (2), Top Rail (4) and Back Rails (5) as shown.
PAGE 3
EEI–2706 LOUNGE STEP 3: Carefully turn over the assembled Lounge Seat (1), Left Frame (2), Right Frame (3), Top Rail (4) and Back Rails (5). Insert 3 pieces of Bolt (A) into the pre-drilled holes on Lounge Seat (1), Top Rail (4) and Back Rail (5) through the bottom pre-drilled holes on Left Frame (2). Use Allen Wrench (B) to tighten Bolts (A) clockwise until secure. Repeat the same steps for Right Frame (3).