Dimensions Guide

1 ¼” Grab Bar rods are formed from
(.040) type 304 stainless steel tubing.
 LR8716D3BN – 16” Ultima Grab Bar
Brushed Nickel Finish, 1 ¼” Bar,
Concealed Screw Mounting
 LR8724D3BN – 24” Ultima Grab Bar
Brushed Nickel Finish, 1 ¼” Bar,
Concealed Screw Mounting
 LR8716D3CH – 16” Ultima Grab Bar
Chrome Finish, 1 ¼” Bar,
Concealed Screw Mounting
 LR8724D3CH – 24” Ultima Grab Bar
Chrome Finish, 1 ¼” Bar,
Concealed Screw Mounting
25300 AL MOEN D R I VE  N OR TH OLMSTED, OH 44070
C OR POR ATE HEAD QU AR TER S: (800) 321 -8809  FAX: [phone]
I N TERN ATI ONAL: (440) 962 -2000  F AX: [phone]
C U STOMER SER VI CE (U SA): 800 -882-0116  F AX: (888) 379 -2720
W W W .MOEN .C OM
Copyright Creative Specialties International 2005 Literature #BA1672
16" Grab Bar 24" Grab Bar
A 16.00 24.00
B 19.15 27.15
C 3.15 3.15
D 2.80 2.80
E 1.50 1.50
1. Ple ase note that screws MUST be mounted into a woo d stud for secure installation.
2. Slide the decorative cover away from the hub end to e xpose the SecureMount™
m ounting flange. Do not remove protective plastic from decorative cover until
indicated later in these instructions.
3. Locate the studs behind the wall by using a stud sensor or other stud locating
m ethod. Studs are usually 16 in. apart; locate the center of each stud.
4. Moving aside the decorative cover as needed, with a pencil, mark three of the
m ounting locations on each of the two grab bar flanges. Two marks to be made
above the grab bar in the area indicated in the illustration below. The third m ark
to be m ade below the grab bar in the area indicated in the illustration below.
De cide whether you would like to position your grab bar horizontally, vertically or
at an angle, remembering that BOTH ends o f the grab bar MUST be positioned
over a wood stud.
5. Moving the decorative cover as far away from the marked slots as possible, d rill a
hole into the m arks, through the slots (as shown in illustration). Position the drill
at a slight a ngle in order to get around the grab bar and decorative cover, making
sure to drill into the woo d stud. If desired, apply silicone caulk to the back of the
de corative cover to guard against water penetration.
6. To mount the grab bar, reposition one end of the grab bar SecureMount™
m ounting flange over the marked holes.
7. Threa d a washer onto each screw. Using the screwdriver, screw the wood scre ws
with wa shers into the SecureMount™ mounting flange at one end of the grab bar.
Then screw the wood screws with washers into the mounting flange at the other
end of the grab bar.
8. Tighten the screws until secure.
9. Slide the decorative cover over the Se cureMount™ mounting flange, rotating to
find the correct fit before snapping into place.
10. Slide decorative covers over SecureMount™ mounting flanges.
Stock Number:_________________________Grab Bars
By Creative Specialties
Materials:
Installation Instructions:
Stock Numbers:
Dimensions:
Ultima Grab Bar
LR8700D3
Home Care Technical Specification