Installation Guide

ManualsBrandsMOEN ManualsBathBelfield Single Hole 1-Handle Bathroom Faucet in Brushed Nickel

INS10604 - 11/16

ONEHANDLE LAVATORY FAUCET

MEZCLADORA MONOMANDO PARA LAVABO

ROBINET DE LAVABO À UNE POIGNÉE

HELPFUL TOOLS

For safety and ease of

faucet replacement, Moen

recommends the use of

these helpful tools.

HERRAMIENTAS

ÚTILES

Para que el cambio de la

llave sea fácil y seguro,

Moen le recomienda usar

estas útiles herramientas.

OUTILS UTILES

Par mesure de sécurité et

pour faciliter l’installation,

Moen suggère l’utilisation

des outils suivants.

PLEASE CONTACT MOEN FIRST

For Installation Help, Missing or Replacement Parts

(USA)

1-800-BUY-MOEN (1-800-289-6636)

Mon - Fri 8:00 AM to 7:00 PM, Eastern

Sat. 9:00 AM to 3:00 PM Eastern

WWW.MOEN.COM

(Canada)

1-800-465-6130

Mon - Fri 7:30 AM to 7:00 PM, Eastern

WWW.MOEN.CA

POR FAVOR, CONTÁCTESE PRIMERO CON MOEN

Para obtener ayuda de instalación, piezas faltantes o de recambio

01-800-718-4345

Lunes a viernes de 8:00 a 20:00 hs.

(Costa Este)

Sáb. 8:00 a 18:30 hs. (Costa Este)

WWW.MOEN.COM.MX

VEUILLEZ D’ABORD CONTACTER MOEN

en cas de problèmes avec l’installation, ou pour obtenir toute pièce

manquante ou de rechange

1-800-465-6130

Du lundi au vendredi :

de 7 h 30 à 19 h, HE

WWW.MOEN.CA

Regístrese en línea:

S’enregistrer en ligne :

www.moen.com/product-registration

Record Purchased Model Number:

Registre el Número de Modelo adquirido:

Inscrire le numéro du modèle acheté :

_______________________

(Save instruction sheet for future reference)

(Guarde la hoja de instrucciones para futura referencia)

(Conserver ces directives pour consultation ultérieure)

Image is for Reference only

(Style varies by model)

La imagen es sólo como referencia

(El estilo varía por el modelo)

L’illustration n’est oerte qu’à titre indicatif seulement

(Le style varie selon le modèle)

Thread seal tape

Cinta para sellar roscas

Ruban pour joints letés

Sealant

Sellador

Mastic

Summary of content (8 pages)

PAGE 1
INS10604 - 11/16 PLEASE CONTACT MOEN FIRST For Installation Help, Missing or Replacement Parts (USA) 1-800-BUY-MOEN (1-800-289-6636) Mon - Fri 8:00 AM to 7:00 PM, Eastern Sat. 9:00 AM to 3:00 PM Eastern WWW.MOEN.COM ONE-HANDLE LAVATORY FAUCET MEZCLADORA MONOMANDO PARA LAVABO ROBINET DE LAVABO À UNE POIGNÉE (Canada) 1-800-465-6130 Mon - Fri 7:30 AM to 7:00 PM, Eastern WWW.MOEN.
PAGE 2
CAUTION — TIPS FOR REMOVAL OF OLD FAUCET: Always turn water supply OFF before removing existing faucet or disassembling the valve. Open faucet handle to relieve water pressure and ensure that complete water shut-off has been accomplished. Icon Legend/Leyenda de Iconos/ Légende des icônes PRECAUCIÓN — CONSEJOS PARA CAMBIAR LA LLAVE MEZCLADORA: Siempre CIERRE la toma de agua antes de quitar la llave existente o desmontar la válvula.
PAGE 3
INS10604 - 11/16 2 1 A G C A Insert Lift Rod (G) into back of Faucet Body (A). Install Gasket (C) into Faucet Body (A). Inserte la barra de cierre vertical (G) en la parte de atrás del cuerpo de la mezcladora (A). Instale el empaque (C) en el cuerpo de la mezcladora (A). Insérer la tige de levage (G) à l’arrière du corps du robinet (A). Placer le joint d’étanchéité (C) sur le corps du robinet (A).
PAGE 4
6 5 <1" (25mm) For Deck Thickness less than 1" Para grosor de cubierta menor de 1" Pour épaisseur de plateforme inférieure à 25 mm Option/Opción/Option >1" (25mm) D E Install Mounting Washer (D) with rubber side up. For Deck Thickness more than 1" Para grosor de cubierta mayor de 1" Pour épaisseur de plateforme supérieure à 25 mm Orient Mounting Nut (E) depending on deck thickness. See image on right for orientation. Thread onto mounting stud.
PAGE 5
INS10604 - 11/16 9 10 J 1 L N M N O 2 O 3 NO NO NON 1. Insert Waste Seat (J) through sink opening. 2. Assemble Drain Body (O) to Waste Seat (J). 3. Tighten by hand. Make final tightening of Drain Nut (N) to Drain Body (O) with wrench. Ensure Pivot Rod opening on Drain Body points towards the wall. Haga el ajuste final de la tuerca del desagüe (N) al cuerpo del desagüe (O) con una llave. Asegúrese de que la abertura del pivote en el cuerpo del desagüe apunte hacia la pared. 1.
PAGE 6
13 Verify white plastic Pivot Rod Seat (P) is in place with beveled side facing out. The Pivot Rod (R) can be installed in two ways. Circle illustration shows the Pivot Rod (R) next to hole in Waste Plug (I). This allows the Waste Plug (I) to be pulled out for cleaning. Box illustration shows the Pivot Rod (R) inserted into the hole in the Waste Plug (I). This prevents the Waste Plug (I) from being easily removed after installation.
PAGE 7
INS10604 - 11/16 16 Tag Etiqueta Étiquette 3 2 1 Hot Caliente Chaud (9.5 mm) (9,5 mm) Cold Frio Froid Optional/Opcional/Optionnel 1. Attach supply lines from faucet to shut off stops. 2. Use a wrench to tighten supplies. 3. Turn on water. Check for leaks. Installation complete. La instalación está completa. L’installation est terminée. 1. Conecte las líneas de suministro de la mezcladora a los topes de cierre. 2. Use una llave para apretar las líneas de suministro. 3. Abra el agua.
PAGE 8
Moen Limited Lifetime Warranty Moen products have been manufactured under the highest standards of quality and workmanship. Moen warrants to the original consumer purchaser for as long as the original consumer purchaser owns their home (the “Warranty Period" for homeowners), that this faucet will be leak- and drip-free during normal use and all parts and finishes of this faucet will be free from defects in material and manufacturing workmanship.