Installation Guide

ManualsBrandsMOEN ManualsBathAdler 1-Handle 4-Spray Tub and Shower Faucet with Valve with Shower Rod in Spot Resist Brushed Nickel (Valve Included)

E10

E11

English

Remove the lever (L)

and lever handle

adapter (J).

Note the position of

the stop. Position the

adjustable tempera-

ture limit stop (D) so

the lever or knob stops

at that position. This

prevents the lever or

knob from being

turned into an unsafe

temperature.

Remove the knob han-

dle (P). Note the posi-

tion of the stop.

Position the adjustable

temperature limit stop

(D) so the lever or knob

stops at that position.

This prevents the lever

or knob from being

turned into an unsafe

temperature.

5.3

After setting the adjustable

temperature limit stop to

the desired position, remove

the lever (L), reattach the

lever handle adapter (J),

adapter screw (K), and lever

(L) – make sure ridges on

back of (J) are to the left of

the tab on (D).

After setting the adjustable

temperature limit stop to

the desired position, reat-

tach the double D washer

(O) and knob (L) – make

sure indicator on the knob

is pointing down.

5.4

Moen products have been manufactured under the highest standards of quality and workmanship. Moen warrants to the

original consumer purchaser for as long as the original consumer purchaser owns their home (the “Warranty Period” for

homeowners), that this faucet will be leak- and drip-free during normal use and all parts and finishes of this faucet will be free

from defects in material and manufacturing workmanship. All other purchasers (including purchasers for industrial, commercial

and business use) are warranted for a period of 5 years from the original date of purchase (the “Warranty Period” for non-

homeowners).

If this faucet should ever develop a leak or drip during the Warranty Period, Moen will FREE OF CHARGE provide the parts

necessary to put the faucet back in good working condition and will replace FREE OF CHARGE any part or finish that proves

defective in material and manufacturing workmanship, under normal installation, use and service. Replacement parts may be

obtained by calling 1-800-289-6636 (Canada 1-800-465-6130), or by writing to the address shown. Proof of purchase (original

sales receipt) from the original consumer purchaser must accompany all warranty claims. Defects or damage caused by the use

of other than genuine Moen parts is not covered by this warranty. This warranty is applicable only to faucets purchased after

December, 1995 and shall be effective from the date of purchase as shown on purchaser’s receipt.

This warranty is extensive in that it covers replacement of all defective parts and finishes. However, damage due to installation

error, product abuse, product misuse, or use of cleaners containing abrasives, alcohol or other organic solvents, whether

performed by a contractor, service company, or yourself, are excluded from this warranty. Moen will not be responsible for labor

charges and/or damage incurred in installation, repair or replacement, nor for any indirect, incidental or consequential damages,

losses, injury or costs of any nature relating to this faucet. Except as provided by law, this warranty is in lieu of and excludes all

other warranties, conditions and guarantees, whether expressed or implied, statutory or otherwise, including without restriction

those of merchantability or of fitness for use.

Some states, provinces and nations do not allow the exclusion or limitation of incidental or consequential damages, so the

above limitations or exclusions may not apply to you. This warranty gives you specific legal rights and you may also have other

rights which vary from state to state, province to province, nation to nation. Moen will advise you of the procedure to follow in

making warranty claims. Simply write to Moen Incorporated using the address below. Explain the defect and include proof of

purchase and your name, address, area code and telephone number.

Moen Incorporated

25300 Al Moen Drive, North Olmsted, Ohio 44070-8022 U.S.A.

Shower heads: Standard 9.5 L/min (2.5 gpm) max. and High Efficiency 7.6 L/min (2.0 gpm) max. or less

For use with automatic compensating valves rated at 5.7 L/min (1.5 gpm) or less

Automatic Compensating Valves:

Posi-Temp® and CFG®: For use with Showerheads rated at 5.7 L/min (1.5 gpm) or higher

ExactTemp® and ioDigital™: For use with Showerheads rated at 9.5 L/min (2.5 gpm) or higher

Moentrol®: For use with Showerheads rated at 4.9 L/min (1.3 gpm) or higher

Using 7/64 inches

hex wrench (N),

insert and tighten

hex screw (M) into

lever (L).

OR insert 1-1/2 inch

Phillips screw (Q).

Tighten screw and

insert cap (R).

5.5

Turn on the hot and cold

water supply to check for

leaks and set temperature

limit stop.

5.1

HOTTEST

120F

(49C)

HOTTEST

120F

(49C)

Rotate the lever OR knob counterclockwise until the water is to the

maximum desired temperature, not to exceed 120 degrees F

(49 degrees C). Seasonal maintenance of the maximum outlet

temperature may be required due to changes in

groundwater temperature. TURN LEVER OR KNOB TO THE OFF

POSITION ONCE THE TEMPERATURE IS SET.

If temperature exceeds 120 degrees, go to step 5.3.

If temperature is less than 120 degrees, go to step 5.4.

5.2

Setting The Temperature Limit Stop and Finishing Your

Tub/Shower Installation

To preserve the finish on the metallic parts of your Moen faucet, apply non-abrasive wax, such as car wax.

Any cleaners should be rinsed off immediately.

Spot Resist™ Stainless and Spot Resist™ Brushed Nickel Finishes:

Moen recommends cleaning the Spot Resist finish with a mild soap, rinsing thoroughly with warm

water and drying with a clean, soft cloth. Never use cleaners containing abrasives (including abrasive

sponges or steel wool), ammonia, bleach or sodium hypochlorite, organic solvents (e.g. alcohols) or other

harsh chemicals (e.g. lime scale removers) to clean the Spot Resist finish, as they may damage the finish.

Failure to comply with these cleaning instructions may void Moen’s warranty

Moen Limited Lifetime Warranty

Care Instructions