Installation Guide

25300 AL MOEN D R I VE  N OR TH OLMSTED , OH 44070
C OR POR ATE H EAD QU AR TER S: (800) 321 -8809  F AX: [phone]
I N TER N ATI ON AL: (440) 962 -2000  F AX: [phone]
C U STOMER SER VI C E (U SA): 800 -882-0116  F AX: [phone]
W W W . MOEN . C OM
Copyright Creative Specialties International
BA1522
Peened Grab Bar rods are formed
from 18-gauge type 304 stainless
steel tubing with a satin finish
8992 – 16” x 32” L- Shape Grab Bar
Stainless Steel Peened Finish
Concealed Screw Mounting
1 ½” Diameter
8994 – 24” x 36” L-Shape Grab Bar
Stainless Steel Peened Finish
Concealed Screw Mounting
1 ½” Diameter Bar
8996 – 24” x 48” L-Shape Grab Bar
Stainless Steel Peened Finish
Concealed Screw mounting
1 ½” Diameter Bar
1. Locate wood for backing using stud finder.
2. Locate and level grab bar. Drill 3 x 1/8” diameter pilot holes for
both end mounting plates.
3. Mark screw locations on center flange and remove bar from wall.
4. Using hex wrench, loosen 3 set screws and remove center
mounting flange.
5. Place center mounting flange on wall and drill 1/8” pilot holes.
6. Install screws.
7. Place L-Bar over center post.
8. Install screws into pre-drilled holes on both ends.
9. Tighten all 3 set screws.
10. Snap on covers.
Stock Number:______________________L-Shape Concealed
Screw Grab Bars Peened Stainless Steel
By Creative Specialties
Materials:
Installation Instructions:
Stock Numbers:
Dimensions:
1 ½” L-Shaped Concealed Screw Grab Bars –
Peened Stainless Steel
8990
Home Care Technical Specification
Compliance:
- ADA Compliant
- Tested to 500 lbs. pull