Flo by Moen Install Guide 1
Meet Flo by Moen.
Flo by Moen Device Wireless Router This install guide outlines the recommended installation for your Flo by Moen system. It provides the necessary information on how to install the system and make it a smooth process for both you and the homeowner.
Contents: What’s in the Box 1 Flo by Moen Device 2 Threaded Connection Fittings 3 Power Adapter 4 Spare O-Rings 5 Installation Spacer 6 Manual Shutoff Hex Key 4
2 1 3 6 4 5 5
Here are the basic tools you’ll need for the install A B C D A Pipe Cutter C Teflon Tape B Measuring Tape D Additional Copper Pipe and Fittings* * Fittings will vary based on the installation type.
Choose from these 3 options to complete the installation: OPTION 1 Solder YOU NEED • Basic Tools • Solder, Flux and Torch OPTION 2 Quick Connect YOU NEED • Basic Tools • Quick Connect or ‘Push to Connect’ Style Fittings OPTION 3 Crimp / Press YOU NEED • Basic Tools • Crimp / Press Style Fittings • Crimping / Press Tool Flo Technologies recommends compliance with all local building and safety codes when installing the Flo by Moen system.
Installation STEP 1 Locate and turn off the main water supply valve STEP 2 Relieve water pressure by opening as many fixtures as possible STEP 3 Install the Device on the main water line after the manual shutoff and after the pressure reducing valve (if applicable) A. Do not solder fittings with the Device on the line. Doing so risks damage to the Device B. Use the Installation Spacer if needed C.
After Installation STEP 4 STEP 5 STEP 6 STEP 7 Slowly turn on the main water Turn off the fixtures opened from supply and look for any possible Step 2 and check for any possible leaks around the point of installation leaks in the installation Connect the power adapter Verify LED status If there is no outlet nearby you may have to drill through the home’s exterior wall to an interior outlet. Verify that there are no pipes or obstructions behind the wall before drilling.
Run a Health Test 1. Open the Flo by Moen App and navigate to the Control Panel. 10 2. Turn off all the fixtures and tap ‘Run Health Test’. Note: Health Tests take up to 9 minutes.
Questions? meetflo.com/support support@meetflo.com 844-MEETFLO 12 Visit meetflo.