Specification Sheet

Technical Specication
Double Paper Holder
BP1888
Stock Numbers:
Materials:
☐
BP1888CH - Double Paper Holder
Chrome Finish
☐
BP1888BN - Double Paper Holder
Brushed Nickel Finish
☐
BP1888BL - Double Paper Holder
Matte Black Finish
Double Paper Holder and Posts are
constructed of zinc. Rods are stainless
steel.
Dimensions:
Installation Instructions:
1) Remove mounting plate from the product post by loosening the setscrew.
2) Position the mounting plate on the wall at desired location with "UP" facing
you. Mark hole locations.
3) Drill two holes as marked using a 5/16" drill bit.
4) Fold ends of the plastic toggle anchor together and insert into each hole on
the wall.
5) Lightlytapanchorsuntilushwiththewall.
6) One at a time, insert plastic pin into each anchor and lightly tap to activate
anchor. Remove pin and repeat on other anchor.
7) Place the mounting plate on the wall over the installed wall anchors with "UP"
facing you.
8) Tighten screws.
9) Place decorative product over the mounting plate with the setscrew facing
down and tighten setscrew.
Stock Number: ____________________ BP1888
Double Paper Holder
25300 AL MOEN DRIVE • NORTH OLMSTED, OH 44070
CONSUMER SUPPORT: [phone] • FAX: [phone]
INTERNATIONAL: (440 ) 962-2000 • FAX: [phone]
CUSTOMER SERVICE (USA): 800-882-0116 • FAX: [phone]
WWW.MOEN.COM
©
2019 Moen Incorporated.
Cleaning Instructions:
Topreservethenenishofthisproduct,cleanonlywithasoftdampcloth.Dry
well. Do not use commercial or abrasive cleaners.
2 “
(51mm)
5/8 “
(16mm)
10-11/16 “
(254mm)
2 “
(51mm)
3-15/16 “
(76mm)