Full Product Manual

Robe Hook is die cast from highest
quality zinc alloy (zamac) and
finished in a high quality powder
coating or metallic plated finish.
 5303CH – Robe Hook
Polished Chrome Finish
Concealed Screw Mounting
 BP5303OWB – Robe Hook
Old World Bronze Finish
Concealed Screw Mounting
 BP5303SN – Robe Hook
Satin Nickel Finish
Concealed Screw Mounting
“BP” skus in wholesale packaging
Cleaning Instructions:
253 00 AL M OEN DRIVE  NORT H OLM ST E D, OH 44 0 70 (800 ) 321 -8809 
FAX: [phone]  INT ERNAT IONAL: (44 0 ) 962 -2000 
FAX: [phone] CUST OM ER SERVICE (USA): 800 -882-0116
WWW.MOEN.COM
©Co p yri g h t Crea ti ve Speci a l ti e s Interna ti o na l Li terature #BA10 7 0
1. Position the mounting plate on the wall at desired location with “UP”
facing you.
2. One at a time, place each anchor screw through the mounting plate,
centered in each large hole. Using a Phillips screwdriver, turn the anchor
screw while applying pressure. Screw will self drill and tap into drywall.
Do not over tighten.
3. Place assembly over the mounting plate, setscrew facing down.
4. Tighten setscrew.
Stock Number:______________________Robe Hook
By Creative Specialties International
Materials:
Installation Instructions:
Stock Numbers:
Dimensions:
Robe Hook
5303
Yorkshire Technical Specification
To preserve the fine finish of this product, clean only with a soft
damp cloth. Dry well. Do not use commercial or abrasive cleaners.