Full Product Manual

25300 AL MOEN D R I VE  N OR TH OLMSTED , OH 44070
C OR POR ATE H EAD QU AR TER S: (800) 321 -8809  F AX: [phone]
I N TER N ATI ON AL: [phone]  FAX: [phone]
C U STOMER SER VI C E (U SA): 800 -882-0116  F AX: [phone]
W W W . MOEN . C OM
Copyright Creative Specialties International
Towel Bars are die cast from highest
quality zinc alloy (zamac) and finished
in a high quality powder coating or
metallic plated finish. Rods are
aluminum. Castings are plated with a
polished brass or polished chrome
finish or powder coated white.
 BP6918CH – 18” Tow el Bar
Polished Chrome Finish
Concealed Screw Mounting
¾” Round Bar
 BP6918OWB – 18” Tow el Bar
Old World Bronze Finish
Concealed Screw Mounting
¾” Round Bar
 DN6918PW – 18” Tow el Bar
Pewter Finish
Concealed Screw Mounting
¾” Round Bar
 BP6924CH – 24” Tow el Bar
Polished Chrome Finish
Concealed Screw Mounting
¾” Round Bar
 BP6924OWB – 24” Towel Bar
Old World Bronze Finish
Concealed Screw Mounting
¾” Round Bar
 DN6924PW (BP6924PW) – 24” Tow el Bar
Pewter Finish
Concealed Screw Mounting
¾” Round Bar
“BP” skus in w holesale packaging
Cleaning Instructions:
1. Position the mounting template on the wall in the desired location. Using a
level, align the template and tape it to the wall.
2. Place each mounting plate on the template with “UP” facing you.
3. One at a time, place each anchor screw through the mounting plate, centered in
each large hole. Using a Phillips screwdriver, turn the anchor screw while
applying pressure. Screw will self drill and tap into drywall. Do not over
tighten.
4. Only insert screw ½ to ¾ of the way into wall.
5. After all screws are installed, tear the template away from the wall
6. Tighten all 4 screws. Do not over tighten.
7. Assemble the towel bar and posts.
8. While assembled, position each end post with the setscrew down and place
over both mounting plates. Tighten the setscrew at the bottom of each base.
Stock Number:______________________Towel Bar
By Creative Specialties
Materials:
Installation Instructions:
Stock Numbers:
Dimensions:
18” & 24” Towel Bar
DN6918 & DN6924
Madison Technical Specification
To preserve the fine finish of this product, clean only with a soft
damp cloth. Dry well. Do not use commercial or abrasive cleaners.
Literature #BA1016