Installation Sheet

25300 AL MOEN DRIVE
•
NORTH OLMSTED, OH 44070
CORPORATE HEADQUARTERS: (800) 321- 8809 • FAX: [phone]
INTERNATIONAL: (440) 962- 2000 • FAX: [phone]
CUSTOMER SERVICE (USA): 800-882-0116 • FAX: [phone]
WWW.CSI.MOEN.COM
Copyright Creative Specialties International 2006
Flanges
are stamped from stainless
steel. Cover is brushed to a satin finish.
q
55
-
F
–
Shower Rod Flange Set
Satin Finish
Concealed Mounting Screws
Two Assemblies per Set
Fits 1” Diameter Rods
1. Position rod in shower opening in desired location.
2. Mark rod ends on walls.
3. Position brackets so that they are centered over rod outlines
and mark mounting holes.
4. Drill starter holes.
5. Attach left bracket to wall using 2” screws (provided).
6. Slide left cover on left end of rod and mount on installed bracket.
7. Place right cover on right end of rod.
8. Insert right bracket into right end of rod.
9. Place end of rod in position and attach bracket to wall with 2”
screws (provided).
10. Snap covers into place over brackets.
Note: Wood blocking is preferable behind all wall surfaces.
If wood blocking is not available, the following optional fastene
rs are
suggested: Tile/Masonry –
Plastic or Lead Anchors; Plaster/Drywall
–
Toggle Bolts
Stock Number:
_____________
__
Shower Rod Flanges
By Creative Specialties
Materials:
Installation Instructions:
Stock Numbers:
Dimensions:
Shower Rod Flange Set
55
-
F
Shower Rods Technical Specification