Specification Sheet

25300 AL MOEN D R I VE  N OR TH OLMSTED , OH 44070
C OR POR ATE H EAD QU AR TER S: (800) 321 -8809  F AX: [phone]
I N TER N ATI ON AL: [phone]  FAX: [phone]
C U STOMER SER VI C E (U SA): 800 -882-0116  F AX: [phone]
W W W . MOEN . C OM
Copyright Creative Specialties International Literature #BA1339
Towel bar posts are constructed of
zinc. Bar is constructed of aluminum.
 YB5818BB – 18” Towel Bar
Brushed Bronze Finish
 YB5824BB – 24” Towel Bar
Brushed Bronze Finish
 YB5818BN – 18” Towel Bar
Brushed Nickel Finish
 YB5824BN – 24” Towel Bar
Brushed Nickel Finish
 YB5818CH – 18” Towel Bar
Chrome Finish
 YB5824CH – 24” Towel Bar
Chrome Finish
Cleaning Instructions:
This product features the Pro+Fit Installation Mounting System. If you do not have
the Pro+Fit Installation Template please use the following instructions. (Note:
only one hole is required per mounting post.)
1. Find the appropriate center to center measurement for the product you are
installing.
2. Mark that distance on the wall where you want to install the product.
3. Use a level to ensure that the pilot holes will be perfectly level.
4. Using ¼” drill bit, drill one pilot hole for each post.
5. Position mounting post to wall by inserting wall anchor into pilot hole and
pressing firmly.
6. Make sure that locking tab on mounting post is facing down (6 o’clock).
7. Tighten wall anchor screw while holding mounting post firmly in place. DO
NOT over tighten (6 – 8 full turns will secure the anchor).
8. Towel bar must be attached to mounting posts as a unit – insert towel bar
into each post.
9. Attach posts by pressing firmly to mounting posts until it clicks. (The square
opening at the base of the post must be facing down to match-up with
locking tab.)
If you are mounting any parts into a hard surface snap off the anti-rotation fins on
the back of the mounting posts.
Stock Number:______________________Towel Bar
By Creative Specialties
Materials:
Installation Instructions:
Stock Numbers:
Dimensions:
18” & 24” Towel Bar
YB5818 & YB5824
Icon™ Technical Specification
To preserve the fine finish of this product, clean only with a soft
damp cloth. Dry well. Do not use commercial or abrasive cleaners.