Specification Sheet

Drawer Pulls are constructed of zinc.

 YB9807BN – Drawer Pull

Brushed Nickel Finish

 YB9807CH – Drawer Pull

Chrome Finish

 YB9807ORB – Drawer Pull

Oil Rubbed Bronze Finish

Cleaning Instructions:

25300 AL MOEN DR IVE  NOR TH OLMSTED , OH 44070

C OR POR ATE H EAD QU AR TER S: (800) 321 -8809  FAX: (800) 848-6636

I NTER NATI ON AL: (440) 962 -2000  F AX: (440) 962-2726

C U STOMER SER VI C E (U SA): 800 -882-0116  F AX: (888) 379-2720

W W W . MOEN . C OM

Copyright Creative Specialties International Literature #BA1558

1. Drawer pulls will require two 3/16” holes.

2. The distance between holes is 3” on center.

3. Using a level, mark the location of the two holes.

4. Use a 3/16” drill bit to drill two holes.

5. Insert the screws into each hole.

6. Place the drawer pull over the screws.

7. Use a Phillips screwdriver to tighten screws.

Stock Number:______________________Drawer Pull

By Creative Specialties

Materials:

Installation Instructions:

Stock Numbers:

Dimensions:

Drawer Pull

YB9807

Waterhill® Technical Specification

To preserve the fine finish of this product, clean only with a soft

damp cloth. Dry well. Do not use commercial or abrasive cleaners.

PAGE 1
Waterhill® Technical Specification Drawer Pull Stock Numbers:  YB9807BN – Drawer Pull Brushed Nickel Finish  YB9807CH – Drawer Pull Chrome Finish  YB9807ORB – Drawer Pull Oil Rubbed Bronze Finish Materials: Drawer Pulls are constructed of zinc. YB9807 Dimensions: Installation Instructions: 1. 2. 3. 4. 5. 6. 7. Drawer pulls will require two 3/16” holes. The distance between holes is 3” on center. Using a level, mark the location of the two holes. Use a 3/16” drill bit to drill two holes.