Instructions / Assembly

25300 AL MOEN D R I VE  N OR TH OLMSTED , OH 44070
C OR POR ATE H EAD QU AR TER S: (800) 321 -8809  F AX: [phone]
I N TER N ATI ON AL: (440) 962 -2000  FAX: [phone]
C U STOMER SER VI C E (U SA): 800 -882-0116  F AX: [phone]
W W W . MOEN . C OM
Copyright Creative Specialties International
Robe Hook is constructed of zinc.
 DN0703BN – Robe Hook
Brushed Nickel Finish
 DN0703CH – Robe Hook
Chrome Finish
Cleaning Instructions:
Stock Number:______________________Robe Hook
By Creative Specialties
Materials:
Installation Instructions:
Stock Numbers:
Dimensions:
Robe Hook
DN0703
Iso™ Technical Specification
To preserve the fine finish of this product, clean only with a soft
damp cloth. Dry well. Do not use commercial or abrasive cleaners.
Literature #BA1398
Directions below are for installation into drywall. If installing product into a
stud, use the wood screws only.
1. Remove mounting posts from the product assemblies by loosening each
setscrew .
2. Position the mounting plate on the w all at desired location w ith “UP” facing
you. Mark hole locations.
3. Drill tw o holes as marked using a 5/16” drill bit.
4. Fold ends of the plastic toggle together and insert into each hole in the
w all.
5. One at a time, insert plastic pin into each of the anchors and lightly tap to
activate anchor.
6. One at a time, insert plastic pin into each of the anchors and lightly tap to
activate anchor. Remove pin and repeat on other anchor.
7. Place the mounting plate on the w all over the installed w all anchors w ith
“UP” facing you.
8. Tighten screw s
9. Place decorative product over the mounting plate w ith the setscrew facing
dow n. Tighten setscrew .