Full Product Manual

25300 AL MOEN D R I VE  N OR TH OLMSTED , OH 44070

C OR POR ATE H EAD QU AR TER S: (800) 321 -8809  F AX: (800) 848-6636

I N TER N ATI ON AL: (440) 962-2000  FAX: (440) 962-2726

C U STOMER SER VI C E (U SA): 800 -882-0116  F AX: (888) 379-2720

W W W . MOEN . C OM

Copyright Creative Specialties International

Drawer Pulls are constructed of zinc.

 DN0707BN – Drawer Pull

Brushed Nickel Finish

 DN0707CH – Drawer Pull

Chrome Finish

Cleaning Instructions:

Stock Number:______________________Drawer Pull

By Creative Specialties

Materials:

Installation Instructions:

Stock Numbers:

Dimensions:

Drawer Pull

DN0707

Iso™ Technical Specification

To preserve the fine finish of this product, clean only with a soft

damp cloth. Dry well. Do not use commercial or abrasive cleaners.

Literature #BA1567

1.Drawer Pulls will require two 3/16” holes.

2.The distance between holes is 3” on center.

3.Using a level, mark the location of the two holes.

4.Use a 3/16” drill bit to drill two holes.

5.Insert the screws into each hole.

6.Place a drawer pull over the screws.

7.Use a Phillips screwdriver to tighten screws.

PAGE 1
Iso™ Technical Specification Drawer Pull Stock Numbers:  DN0707BN – Drawer Pull Brushed Nickel Finish  DN0707CH – Drawer Pull Chrome Finish Materials: Drawer Pulls are constructed of zinc. DN0707 Dimensions: Installation Instructions: 1.Drawer Pulls will require two 3/16” holes. 2.The distance between holes is 3” on center. 3.Using a level, mark the location of the two holes. 4.Use a 3/16” drill bit to drill two holes. 5.Insert the screws into each hole. 6.Place a drawer pull over the screws. 7.