Instructions / Assembly

25300 AL MOEN D R I VE  N OR TH OLMSTED , OH 44070
C OR POR ATE H EAD QU AR TER S: (800) 321 -8809  F AX: [phone]
I N TER N ATI ON AL: [phone]  F AX: (440) 962 -2726
C U STOMER SER VI C E (U SA): 800 -882-0116  F AX: [phone]
W W W . MOEN . C OM
Copyright Creative Specialties International Literature #BA1401
Directions below are for installation into drywall. If installing product into a
stud, use the wood screws and washers provided only.
1) Position the mounting template on the w all in the desired location.
2) Using a level, align the template and tape it to the w all.
3) Drill tw o 5/16” holes as indicated on the template
4) Remove the template from the w all.
5) Fold ends of the plastic toggle together and insert into each hole in the w all.
6) Lightly tap anchors until flush w ith the wall.
7) One at a time, insert plastic pin into each of the anchors and lightly tap to activate
anchor. Remove pin and repeat on all anchors.
8) Remove mounting posts from the product assemblies by loosening each setscrew.
9) Place the mounting plate on the w all over the installed w all anchors with “UP”
facing you.
10) Insert screws through the mounting plate into the anchors. Tighten the screws.
11) Assemble the tow el bar and posts.
12) While assembled, position each end post w ith setscrews facing down and place
over both mounting posts. Tighten the setscrew at the bottom of each post.
Towel bar posts are constructed of
zinc. Bars are constructed of
aluminum.
 DN0722CH – 24” Double Towel Bar
Chrome Finish
 DN0722BN – 24” Double Towel Bar
Brushed Nickel Finish
Cleaning Instructions:
Stock Number:__________________ Double Towel Bar
By Creative Specialties
Materials:
Installation Instructions:
Stock Numbers:
Dimensions:
24” Double Towel Bar
DN0722
Iso™ Technical Specification
To preserve the fine finish of this product, clean only with a soft
damp cloth. Dry well. Do not use commercial or abrasive cleaners.